Electronics Forum | Wed Sep 05 17:37:56 EDT 2001 | seand
Hello Jeff, If you have components on your board be careful of how low the frequency is that you will be applying to your board. Ultrasonics are great for cleaning stencils and bare boards at around 40kHz. These frequencies (and Lower)may however
Electronics Forum | Mon Feb 19 13:31:25 EST 2001 | billschreiber
Hello Mark, EPA Certification can be a tremendous help to the user that is evaluating new cleaning processes. Let�s face it, if it wasn�t for the Earth�s ozone layer, everyone would still be using CFCs and a vapor degreaser to clean stencils, PCBs
Electronics Forum | Tue Apr 17 09:38:04 EDT 2001 | CAL
With some help from our good Friends at Agilent Technologies our RF Lab includes testing up to 100GHz. Equipment includes Vector network analyzer, signal analyzer, dual channel power meter, noise filter meter, advanced impedance analyzer (including
Electronics Forum | Thu Jul 22 16:36:06 EDT 1999 | Mike Konrad
Scott is right, Alpha' 2110 is a good saponifier (be careful though as it can dull your leads). Saponifiers in general are better if used in an aggressive spray-in-air system. Low agitation immersion systems (heated baths or refurbished vapor degre
Electronics Forum | Thu May 23 22:17:47 EDT 2002 | davef
Not intending to undercut Mike's offer, but to compliment it. Consider asking Heraeus for guidance about cleaning the residues from reflowing your paste. Some NC flux res: * Cannot be cleaned. * Can be cleaned after a relatively short period of tim
Electronics Forum | Wed Mar 24 21:51:23 EST 2004 | davef
Dreamy It sounds like you are having fun in your new job. Saponifier. Alkaline chemicals, added to water, that convert rosin/resin flux residues in the water to soluble soaps. Generally, saponifiers are better if used in an aggressive spray-in-ai
Electronics Forum | Thu Sep 06 10:34:21 EDT 2001 | Mike Konrad
Hi Jeff, Sean is correct. Although ultrasonic technology will work in post-reflow de-fluxing applications, you will receive concerns regarding ultrasonic �damage� to wire bonded components. Much has been written to combat this belief but the conce
Electronics Forum | Tue Jul 01 21:40:04 EDT 2008 | davef
Vapor degreasing systems * Thermal Equipment [Baron-Blakeslee]; Torrance, CA; thermalequipment.com * Exselect Engineering; Concord, ON CAN; exselect.com * Branson Ultrasonics; Danbury, CT; bransoncleaning.com * Greco Brothers; Providence, RI; grecob
Electronics Forum | Tue Dec 22 12:08:06 EST 2015 | aqueous
The overwhelming technology used in post-reflow cleaning of electronic assemblies is aqueous. Prior to the 1990's, solvents and vapor degreasers dominated the cleaning industry. After the popular solvents were banned via a United Nations treaty, alte
Electronics Forum | Mon Jul 24 15:10:37 EDT 2006 | carln
Here are some additional comments that have been posted on the CircuitNet web site: Fist, the answer is the same regardless of the specific paste type, (leaded or non-leaded). High pressure sprays should never be applied to a stencil. Stencils are