Electronics Forum | Fri Jan 16 15:29:48 EST 2015 | travishemen
We are trying to network our Universal VCD 8 and Radial 8. I have everything I need except for the driver disks for the Radisys EXM-10A network card. Does anyone have a copy they would be willing to share?
Electronics Forum | Fri Jan 16 16:59:31 EST 2015 | dilogic
We do not have such machines, only GSM's but network card is the same. Is Radial (VCD8) running on OS/2 too?
Electronics Forum | Fri Jan 16 17:08:35 EST 2015 | travishemen
Yes, both the radial 8 and the VCD 8 run on OS2.
Electronics Forum | Sun Jan 18 02:52:28 EST 2015 | dilogic
I've successfully networked our GSM's. They all run OS/2 Warp 3.0 which already has drivers for the card. Which OS/2 version your machine runs on?
Electronics Forum | Wed Dec 09 17:12:08 EST 2015 | ttheis
Hi Travis- We're trying to do the same thing. Did you have any luck finding the driver disks for the EXM-10A card?
Electronics Forum | Tue Jan 13 08:08:37 EST 2009 | leemeyer
I am assuming that the card that was changed was the motor driver card. Did they change the card with a known good board or just swap the X and Y cards. If they swapped cards it appears that the card that is now in the X motor slot is bad. Open the a
Electronics Forum | Thu Feb 10 12:47:47 EST 2022 | bukas
1. disable driver update (system and regkeys) 2. reboot in safe mode 3. disconnect internet 4. uninstall any nvidia driver using IO Bit uninstaller 5. uninstall nvidia and intel drivers using DDU 6. reboot in normal mode 7. install intel driver from
Electronics Forum | Mon Feb 22 10:19:57 EST 2010 | swag
Check/reseat all connections on axis driver card and from driver card to step motor. On older MpM's it is common to get a bad connection on the connector for axis driver power and blow components on your driver board. Reseating these connectors mig
Electronics Forum | Wed May 19 09:32:28 EDT 2004 | Mr Fix it - MPM
Sounds to me like the driver for the tactile is not working. The tactile has three components to it. The first is the switch, the second is the pneumatic up/down actuator and the third is a small motor in the tactile assembly. The motor has a driv
Electronics Forum | Wed Sep 10 06:31:32 EDT 2003 | qp1
Dear We have several 4796HSP in production We often have problems with the driver card D2332, S-ver1.32 Wver0.11 For replacement they are quite expensive Can someone tell me how to avoid this problem or how to repair these cards Or is this a known p
