Electronics Forum | Fri Jan 24 09:26:29 EST 2003 | pjc
I sent you a couple of charts to assist with your troubleshooting. One is the Electrovert Wave Solder Troubleshooting chart and the other is Sandia Labs/Electrovert Optimum Solder Contact Time. Electrovert has a 6 deg. conveyor angle standard on the
Electronics Forum | Fri May 05 14:32:14 EDT 2000 | C.K.
I read my posting again, and it didn't sound right....what I meant was slow down your conveyor speed BY .5 to 1 FPM. So, if you're running @ 4 FPM, slow it down to 3.0 to 3.5 FPM.
Electronics Forum | Mon May 08 16:01:11 EDT 2000 | John
I was running the conveyor at 3.75 when we started the discussion with Electrovert. Unfortunately, foam fluxing is a fact of life for us. Our products have open contact relays that can become contaminated by spray fluxing. Titration is our only me
Electronics Forum | Tue May 02 17:11:17 EDT 2000 | John
My company just purchased a Vecta (E-vert) wave soldering machine. Bridging has become a serious issue, both on SMT components and thru hole. We are currently seeing about 500 ppm. The products that are being run now were run previously on our old
Electronics Forum | Wed May 03 11:52:09 EDT 2000 | SONO-TEK CORPORATION
John - CK can probably help you further once you answer those questions, but for now what's your top side temp and how are you applying flux? Two of the primary causes for bridging are conveyor instability (vibration) and turbulance in the solder wa
Electronics Forum | Fri May 05 11:58:25 EDT 2000 | John Sims
We are using NR300F from Alpha. Topside board temp is 220 deg. F. We have 3 bottom side convection preheaters, and we use a foaming fluxer. The machine (except for the rotary chip wave) is almost identical to the old econopak. An electrovert appl
Electronics Forum | Fri May 05 14:30:11 EDT 2000 | C.K.
I'd have to disagree with the Electrovert applications guy. I'd recommend SLOWING down the conveyor between .5 to 1 FPM - effectively, you're REDUCING contact length (because contact length = dwell time * conveyor speed), hence getting better peel-o
Electronics Forum | Mon Jun 13 11:48:33 EDT 2005 | CMiller
We got a F04 error (internal Memory fault) on the shared drive and entered 8 in location N001 as per the maint manual and cycled the power. I then set all the locations listed in the manual to thier default settings. Now the motors do not run to thei
Electronics Forum | Mon Mar 13 14:26:45 EST 2006 | Wave Master Larry
Well, im not sure what plane you guys are on, but I can back up my what im talking about. Ya see I wnet to Soltec traingin back in 1995 for our new wave. I got a diploma proofing that I know what i'm talking about. no one else in my company has on
| 1 |
.gif)
winsouce.jpg)