Electronics Forum | Fri Nov 03 07:28:27 EST 2006 | davef
Via filling methods are: * Tenting * Plugging * Capping * Flooding Tented Via. A via covered with dry film soldermask; the via is not filled. When tenting from both sides there may be issues with trapped air that expands during mass soldering. Plug
Electronics Forum | Thu Oct 31 11:08:12 EST 2002 | soupatech
Being very new to SMT I won't assume I know what the problem is but.... I had lots of air pockets in solder joints, 95% of the boards. Everyone I spoke to thought it was a problem with my process but when one board was sent to our supplier they admi
Electronics Forum | Thu Feb 21 16:57:02 EST 2008 | flipit
If the vias are large and don't always tent, you can have your pcb supplier double mask the pcb. I do this for COB assembly sometimes because the globtop wicks through the vias and also causes air bubbles in the globtop.
Electronics Forum | Wed Jan 17 12:10:47 EST 2018 | guilherme_castro
I have the follwing problem in our proccess we have to many problem with via hole and trought plated holes like voids air bubbles . During the eletricial test process our machine is not detecting this problems , the voids and air bubbles How
Electronics Forum | Sat Jul 11 03:01:29 EDT 2020 | researchmfg
The bubble inside BGA ball locate at via in pad and apply the resin plug hole.You shall check the cooper plating quality on PCB pad. If there is thin plating or broken on the pad then air will come from the resin plugged via and be trapped inside the
Electronics Forum | Tue Jul 15 16:12:23 EDT 2008 | boardhouse
Hi Armynski, I sell for an offshore board house, yes, it is common for offshore board shops to fill vias. The bubble is caused by air entrampment within the hole it self, when heat is applied during Hot air and the via is covered on both sides the e
Electronics Forum | Tue Nov 14 18:38:59 EST 2006 | Brandon
Hello all, I am having an issue with some boards on our Wave Solder. It is a Pb free wave and These particular boards are exibiting A LOT of what I call solder bubbles in the larger than usual vias and un-used thru holes. Settings: 4 inch/min 144c to
Electronics Forum | Mon Mar 30 16:02:44 EST 1998 | Michael Allen
| We have successfully put .016" vias in .030" pads. | There is no issue with .030" solder balls, since | the actual volume of the .002" via in pad is small | compared to the ball+solder paste volume. | We did notice random bubbles where, apparentl
Electronics Forum | Wed Mar 25 16:38:21 EST 1998 | Steve Joy
We have successfully put .016" vias in .030" pads. There is no issue with .030" solder balls, since the actual volume of the .002" via in pad is small compared to the ball+solder paste volume. We did notice random bubbles where, apparently, the sol
Electronics Forum | Wed Mar 25 19:41:01 EST 1998 | Earl Moon
| We have successfully put .016" vias in .030" pads. | There is no drain off with .030" solder balls, since | the actual volume in the .002" depression is low. | We did notice random bubbles where, apparently, the | solder reflowed and trapped the a