Electronics Forum | Tue Jul 04 16:13:09 EDT 2000 | TOOLMANTIM
HELLO BILL I HAVE SOME QUESTIONS FOR YOU 1:HOW ARE YOU CLEANING YOUR STENCIL 2:ARE YOU SINGLE OR DOUBLE PRINTING. 3:ARE YOU USEING VACUUM FIXTURES OR NOT? HERE ARE SOME OTHER THINGS TO TRY. IF YOU ARE CLEANING YOUR STENCIL OFTEN BECAREFUL OF USEING
Electronics Forum | Tue Jun 27 10:36:45 EDT 2000 | Bill Bannister
We've been experiencing solder balls on 0805 caps. We have modified the reflow profile and had some success, but some balling still persists. The balls always form from under the cap between the lands. I measured the distance between the lands at .03
Electronics Forum | Wed Nov 14 13:05:40 EST 2007 | rgduval
I had one project with micro-vias in 0805 and larger pads, with no issues. But my most recent project had vias that were larger than the 0402 pads that the via was in. To the point that for a number of the lands, there was no visible pads (a couple
Electronics Forum | Tue Jun 27 11:16:33 EDT 2000 | Christopher Lampron
Hello Bill, Ioan's idea's are good. One more thing that you may want to consider is using a "Home Plate" aperture on your stencil for the aforementioned caps. The idea is to put a smaller amount of solder paste directly underneath the component. This
Electronics Forum | Fri Jun 07 09:50:13 EDT 2019 | teejsd
Closer pics at angle would seem to support soldermask delam. And I am now wondering if our no clean flux is getting properly inactivated where it is sitting under the mask.
Electronics Forum | Tue Jun 27 10:51:42 EDT 2000 | Ioan
Hi Bill, there are a couple of things you should check. Most likely you have too much paste which is squashed at the insertion of the cap. - the paste height, around 7 mils should do. Too much paste will cause shorts under the cap at insertion which
Electronics Forum | Fri Jun 07 11:10:08 EDT 2019 | teejsd
We also have a Foresite C3 for spot testing for ionic contamination. I didn't use it at this spot, but used it some other spots around the PCB that showed this color change and with our C3 we were passing IPC standard for ionics. But I was wonderin
Electronics Forum | Thu Aug 23 15:45:48 EDT 2001 | slthomas
So, we've already addressed the tombstoning on these guys by adopting the mfr's (Pana.) recommendations for pad size and spacing. Problem is, we have pretty bad wetting of some of these parts. The rest of the board we use them on looks great, nice
Electronics Forum | Mon Feb 06 10:02:14 EST 2006 | Yash Sutariya
Sorry. I actually should clarify those slides. Black pad is not associated with tented vias. Also, you can tent vias with soldermask, but this requires the immersion gold process to be completed prior to soldermask. As such, all copper features (
Electronics Forum | Thu Sep 01 11:25:21 EDT 2005 | chunks
Unless it is peppered with via holes. Then it depends on the size of the pad and via holes.