Electronics Forum | Mon Mar 19 08:12:24 EDT 2007 | RA
Dear ALL, For Inspecting ( Visual)the post soldering defects ( SMT ) which equipment is best i.e either optical microscope or video microscope, pls clarify with ur best suggesstion.
Electronics Forum | Mon Mar 19 17:09:38 EDT 2007 | jmelson
A binocular microscope gives just a little more info than the video would, as you have views from two slightly different angles. A good stereo microscope gives more resolution or sharpness than video can. You have to take the time to set up the eye
Electronics Forum | Thu Mar 15 03:38:11 EDT 2007 | imetrex
Please dewscribe the advantages and disadvantages of digital video inspection syatem vs optical microscope system for visual inspection of elctronic assemblies . Also please advise the suitable system (whether optical or video microscope )for visula
Electronics Forum | Wed Mar 14 01:51:55 EDT 2007 | CHITRA K
We would like to buy a good microscope for visual inspection of SMT PCBs especialy for highly populated PCBs assembled with fine pitch components including BGAs . Please advise a suitable type of equipment visula inspection for volume production. A
Electronics Forum | Wed Sep 16 18:25:47 EDT 2009 | larob57
(http://forums.xbox-scene.com/index.php?showtopic=691556) I can make some more pic's for you to see and I will post them in photobucket.Go to my page at this link and then click on my album (http://s1007.photobucket.com/albums/af192/repairman52/)
Electronics Forum | Fri Aug 10 13:28:19 EDT 2001 | Hussman
Hey John, You're not alone, a lot of people have the same problem with different machines and material. What is your specific problem, just keeping SPC control? Or are your defects at the wave from the glue too? If it's a process problem, I found
Electronics Forum | Thu Mar 15 17:19:03 EDT 2007 | bT_Solutions
By "digital video inspection system", I'll assume you mean AOI. I have only dealt with one AOI system, YesTech, and in my opinion I'd say that AOI is much more consistent and advantageous than manual microscope inspections. Specifically, with the Yes
Electronics Forum | Mon Aug 04 11:34:45 EDT 2014 | spoiltforchoice
Well our small UK based company is I guess in a similar situation, there isn't the volume or value to justify an expensive solution for fiddly rework tasks. But it would certainly be nice to have one and may become more important in future as people
Electronics Forum | Tue Jul 28 17:23:58 EDT 1998 | Robert Steltman
| | We are about to run our first BGA devices and would appreciate some confirmation on a few points. | | First some details: | | PCB & Device: | | ============= | | 1) 16 layer (4 power, 4 gnd, 8 signal) | | 2) gold on nickel finish | | 3) ceramic
Electronics Forum | Mon Aug 17 02:57:47 EDT 1998 | Bob Willis
| | Looking for Suppliers of surface mount wetting balance equipment. | Bucky: Section 6 of the ANSI/J-STD-002 specification lists wetting balance suppliers. Dave F I like and continue to use the Multicore system. I have had many ours using the sys
| 1 |
.gif)
.gif)
