Electronics Forum | Mon Oct 14 12:39:38 EDT 2013 | lkavan
Dear friends, I have another question about Tenryu MT5530. There is a wrong software on PCMCIA memory card in one machine. Can you help me how to read and write this card. I tried to insert it into notebook PCMCIA slot and it doesn't work, Windows ca
Electronics Forum | Fri Oct 18 11:56:22 EDT 2013 | hegemon
You might try testing prior to using the Silicone if possible. Also you might try to qualify your cleaning process rather than the individual board. Clean an unrelated assembly and test it in your Ionagraph. Assuming it passes, Clean your subject a
Electronics Forum | Mon Oct 28 08:27:53 EDT 2013 | emeto
There are many profilers(physical devices) on the market. Most of them have software that makes predictions based on information about the paste, oven model...., but I wouldn't trust the predictor as on your boards you will have different parameters
Electronics Forum | Fri Nov 01 17:32:34 EDT 2013 | dhruv_trylene
I am sorry for not being clear enough... We have a FUJI CP642 and a IP3 machine. At present, we have to create part data for each and every part used in a job, which consumes a lot of time. I was just wondering if there was a way to minimize this?
Electronics Forum | Mon Nov 04 12:18:12 EST 2013 | jimmyboz
Its been a couple years since I worked with Flexa every day. The program uses the part number and this should reference some shape library. If you understand the nomenclature of this library, it should get you close. I don't remember if the default
Electronics Forum | Mon Nov 04 12:21:03 EST 2013 | jimmyboz
Its been a couple years since I worked with Flexa every day. The program uses the part number and this should reference some shape library. If you understand the nomenclature of this library, it should get you close. I don't remember if the default
Electronics Forum | Thu Oct 31 02:43:55 EDT 2013 | hqew2013
The smallest finished hole available for 2 layer board is .020”. The smallest finished hole available for 4+ layer board is .014”. All holes are round and drilled through from top to bottom layer of board. No blind or buried vias. For holes = .15
Electronics Forum | Thu Oct 31 11:54:10 EDT 2013 | ke6zoy
I work in a leaded paste world due to aerospace environmental requirements. There are a few cases where parts are only available from suppliers as RoHS. Can anyone recommend how to process these into a leaded assembly? Is it just reflowing at a hi
Electronics Forum | Thu Oct 31 12:33:14 EDT 2013 | pbarton
You should have no difficulty with QFN or QFP parts when using non-RoHS solder. The QFP's are most likely to have tin plated leads and the metallisation on the QFN lands the same, or ENIG. Check the component part datasheets to verify the plating an
Electronics Forum | Thu Oct 31 12:37:37 EDT 2013 | pbarton
You should have no difficulty with QFN or QFP parts when using non-RoHS solder. The QFP's are most likely to have tin plated leads and the metallisation on the QFN lands the same, or ENIG. Check the component part datasheets to verify the plating an