Electronics Forum | Mon Oct 24 16:24:53 EDT 2011 | smdbert
Hello, My name is Bert i'm working by LéTÉ with two mydata smd machines and have sometimes several problems ,most of the problems try to solve it by myself but sometimes the boss also helps and i write the errors in map but first of all 4 questions
Electronics Forum | Wed Oct 26 11:02:41 EDT 2011 | dyoungquist
TP9 machines are good, but old machines. We ran a TP9 for many years. As the machine got older it required more and more maintenance and had more frequent small issues similar to what you are seeing. We only saw 1 of your 4 issues specifically whi
Electronics Forum | Wed Oct 26 20:20:28 EDT 2011 | machinehead
Our Company is suffering a Huge lose in scrap parts. I recently took over the My12 MyData SMT Machine. And I'm trying to find a remedy to the lose of exposed parts when pulling tape out of feeders. I've tryed alot of things? But still no Luck. I'm lo
Electronics Forum | Thu Oct 27 13:42:12 EDT 2011 | sjs2303
I know what you mean but have never found a tool that would do this sufficiently. For higher value parts you should keep them in a bag for the next time you run a job that uses that part and hand fit them. The nature of the feeders means that you w
Electronics Forum | Fri Nov 04 22:03:35 EDT 2011 | machinehead
Yeah that is a drawback to those feeders. The > plastic part that is mentioned in one of the > responses is okay but you have to be real careful > when pulling the tape out before you can put that > part on. Mydata always says to leave the reel
Electronics Forum | Thu Oct 27 16:49:05 EDT 2011 | CPI
I’m looking for information regarding Reach and what a contract manufacture is required to supply their end customer. We are just getting our feet wet with this requirement and I want to make sure we nail this out of the gate. Is it just the MSDS tha
Electronics Forum | Sun Oct 30 20:39:08 EDT 2011 | conjugate
I`m now doing my major project related to Automated surface cleaning for PCB after I found out there`s a lot of problem with rejected PCBs, which is almost of them caused by the contamination from the materials itself. After trying a few solutions by
Electronics Forum | Mon Oct 31 18:18:21 EDT 2011 | conjugate
Thanks a lot. I`ve been doing a research for existing products as well and yes Teknek is quite helpful. Now I need to do some simulation analysis, collect some data and compare with manual operation in order to proof that this is a good and strong pr
Electronics Forum | Wed Dec 07 13:10:32 EST 2011 | conjugate
Hi Reese, the contamination is coming from the material of the PCB itself. Basically, there`re failure observed in the products from electronics factory. preliminary analysis been done, the main board not properly functioning due to bad solder. next
Electronics Forum | Sun Oct 30 20:41:57 EDT 2011 | conjugate
I`m now doing my major project related to Automated surface cleaning for PCB after I found out there`s a lot of problem with rejected PCBs, which is almost of them caused by the contamination from the materials itself. After trying a few solutions by
