Electronics Forum | Sat Dec 17 14:14:32 EST 2011 | shakerbose
We currently have several Vitronics Re-flow Machines, and I would like to know if I can move software V.10.01.00 from a XN1030 to a XA0820 machine running V. 08.00.00. Both machines have the same Controller Hardware Version A32.1.00
Electronics Forum | Wed Jul 11 13:29:17 EDT 2007 | cyber_wolf
Hi, We recently purchased an XPM1. It has 3 squealing blower motors. Of course they are the ones on the bottom zones. I have read the procedure in the tech manual. Does anyone have any experience replacing these blowers? Can you offer me any helpf
Electronics Forum | Wed May 27 13:04:49 EDT 2009 | cyber_wolf
I am not sure on Panasonic or Assembleon. Last I heard, Universal was getting ready to be liquidated. I haven't used DEK printers. Vitronics ovens are very nice. We have 3 XPM2's and an XPM1. They are work horses.
Electronics Forum | Wed Mar 13 06:37:24 EDT 2013 | jlawson
Not knowing XPM ovens , have zones are usually top heat and bottom, you replaced one heater panel-platten thus have a another above or below, maybe one above or below also is faulty causing heat spot on one side of oven ?
Electronics Forum | Wed Jul 11 14:44:33 EDT 2007 | cyber_wolf
Ya I found that out while pulling the motor wires out of the terminal blocks.
Electronics Forum | Mon Jul 16 19:29:13 EDT 2007 | bga_kid
I have some advice...... rid your self of that beast. and try a OmniExcel
Electronics Forum | Tue Jul 17 13:10:29 EDT 2007 | cyber_wolf
Thanks chunks. Good tip.
Electronics Forum | Tue Jun 03 10:38:20 EDT 2014 | patel_daxa29
Thank You Chris.
Electronics Forum | Fri Feb 16 04:15:57 EST 2018 | sachinverma
hi , please check the main S/w. of the Reflow machine.
Electronics Forum | Fri Sep 05 11:32:31 EDT 2008 | realchunks
I just bought some of XPM3 series. according to Vitronics, you shouldn't go through more than two quarts a year per each oven. Have you experienced this? If not then I too would be interested in a 2nd source.
