Electronics Forum | Thu Oct 18 18:37:59 EDT 2007 | mefloump
Hello all, I was wondering if anyone knew of a stateside distributer for Yaskawa? I am looking for a VS-606V7 200V single phase, .55kW, model #CIMR-V7CCB0P4, in case you happen to have one laying around. It is for a Soltec Vitronics Selective Solde
Electronics Forum | Fri Apr 30 10:56:27 EDT 2004 | Bryan She
We tested J6 open on .5mm pitch CSP(In fact,only resistance much lower than normal).J6 is one of the corner ball of the CSP.Defect rate is about 3%. Stencil:4 mil thickness,10 mil square aperture, solder mask openning:10 mil diameter circle. Board fi
Electronics Forum | Tue Mar 15 18:42:57 EST 2005 | simmcircuits
Hi, Can anyone give me a bit of an advise or tip on how to reduce the flux residues on the board when it comes out of the wavesolder machine. The Vitronics Soltec 6622CC that we are using have been producing boards like this for years and people her
Electronics Forum | Sun May 23 07:13:56 EDT 1999 | Scott Cook
| Has anyone had any experience or data using vibration during the reflow process. | We introduced a vibration device attached to the fixed rail on a Vitronics reflow oven. The reason was to prevent skewing on large PLCC devices. The process worked v
1 |