Electronics Forum | Tue May 21 13:56:05 EDT 2013 | jayjjackson
I'm looking for heater panels ,4500W , 220/440V for our conceptronics reflow oven.
Electronics Forum | Fri Jun 06 15:12:05 EDT 2008 | tomwho
Can anyone give me a contact for someone who sells used vitronic reflow oven parts. I am look for heater panels or heater wire for a vitronics smr-820 reflow oven,or some place that can replace the heater line in them. Thank you
Electronics Forum | Wed Mar 13 06:37:24 EDT 2013 | jlawson
Not knowing XPM ovens , have zones are usually top heat and bottom, you replaced one heater panel-platten thus have a another above or below, maybe one above or below also is faulty causing heat spot on one side of oven ?
Electronics Forum | Mon Mar 11 07:58:59 EDT 2013 | cyber_wolf
So I have this issue with my 1240. During my weekly oven surveyor check I get a software alarm that says I am out of tolerance. Probe #3 which is closest to the hinge side of the oven is approx. 10 degrees hotter in zone 12 than the other 2 probes o
Electronics Forum | Tue Feb 01 09:07:50 EST 2000 | Gary Mitchell
Looking for spare parts for a Vitronics 722 reflow oven, heating elements or panels. Thanks Gary Mitchell Innovative Circuits Inc
Electronics Forum | Thu Oct 28 20:13:39 EDT 2004 | grayman
The same with Russ, I would look at Vitronics and BTU. based on my experience they give best results especially on the profile. Maintenace is also superb! BTU has modular blower, heater T/C assy. Vitronics is "XPM - NO PM System" Now, BTU offers lif
Electronics Forum | Mon Oct 17 14:00:14 EDT 2005 | ricardof
for sure it's an excelent topic, in Mexico we've used almost any brand in the market (Research, Heller, Electrovert, Rhem, Vitronics, Conceptronics, BTU) and after all those names, we could see that Vitronics is a good opton, good service, not too mu
Electronics Forum | Wed Jan 18 10:35:17 EST 2006 | pms
Thanks folks !! I'll experiment with the bottom side heaters. Unfortunatly I don't think our Vitronics-Soltec oven has the option for adjusting the heater fan speeds. And I'll check the conveyor chains. This is our first project using 0402 parts, wh
Electronics Forum | Mon Mar 11 09:46:04 EDT 2013 | cyber_wolf
The surveyor is a a plate that I use to "survey" or verify the oven on a weekly basis. The data logger or profiler is the actual unit that follows the board through the oven to take readings. I don't think the zone thermo couple that measures temp a
Electronics Forum | Mon Mar 11 09:38:05 EDT 2013 | markhoch
Maybe I misinterpreted, because different people have different names for different devices, (i.e... I believe that the device that you refer to as your "surveyor", I refer to as a "profiler"), but did you already determine that your oven thermocoupl
winsouce.jpg)