Electronics Forum | Thu Apr 23 07:51:45 EDT 2009 | scottp
Every paper I've seen published shows that BGA voids either have no effect or actually give a slight improvement. The one exception are voids with a root cause in bad incoming boards, such as champagne voiding where nearly the entire interface is go
Electronics Forum | Tue Feb 19 22:50:00 EST 2008 | amarpreet41
Do you of reducing hole size of DIMM connector will improve solder voids??
Electronics Forum | Sun Aug 19 15:34:20 EDT 2007 | davef
What are you trying to do: * Improve hole fill? * Reduce PTH voiding? Hole fill: Search the fine SMTnet Archives for stuff like: http://www.smtnet.com/forums/Index.cfm?CFApp=1&Message_ID=36063 PTH voiding: Ideally, there are no voids. We're unawar
Electronics Forum | Tue Mar 06 14:10:52 EST 2001 | CAL
Are the voids in the balls of a BGA? Are you verifying this through x-ray if they are? some voids depending on size and location are some what accepted. Solder paste type? Solder paste date code? Humidity high? PCB's been stored in a truck trailer?
Electronics Forum | Thu Feb 21 04:41:37 EST 2008 | mun4o
hi,Toni, we use only FR4.Some of PCB we order in China and Taiwan.With these PCBs we can't any problem.Other PCB we order here in Bulgaria.The problems with voids start last year - we have voids only in PCBs from Bulgarian factory.The process is sam
Electronics Forum | Wed Feb 28 19:44:50 EST 2001 | pzohbon
I am having problems with voids in our soldering process. I believe it to be the fact that we use a no clean flux without control on how the boards are handled (gloves, procedures, etc.) Does anyone have suggestions on the appropriate place to start?
Electronics Forum | Thu Mar 01 11:43:08 EST 2001 | dason_c
Not enough info, when you say no clean flux, is it for wave soldering process, please provide more detail, SMT or wave, is it all the joint which you find the void? Rgds
Electronics Forum | Wed May 06 04:31:42 EDT 2009 | radzi
We have prob Solder voids for Connector, Micro D. We used HMP solder wire and pcb thickness is 0.093".
Electronics Forum | Wed Feb 20 07:31:59 EST 2008 | davef
We'd go with the formula above.
Electronics Forum | Fri Mar 02 08:52:20 EST 2001 | markkrmp
Are your voids looking like blow holes also? Is this only occurring on the solder joints of the Thru Hole components and Via's? Or does this happen on SMD pads? My experience is that we have seen this but only with some of our older PCB's which are
