Electronics Forum | Mon Aug 31 19:15:36 EDT 2020 | dilogic
We have GSM2 with FlexJet heads (an older one). There are 7 sensor amplifiers (with LED indicators) for touchdown detection and one for z-safe detection which is of a different type (with numeric LED indicator). I can't find anywhere what the right n
Electronics Forum | Fri Sep 08 22:37:30 EDT 2017 | ttheis
If you have two changers and only one head, make sure there is only one open port (one changer should be filled up and the other should have one open hole.) The head should be full of nozzles as well. As you mentioned go into the diagnostics and act
Electronics Forum | Fri Sep 14 19:55:06 EDT 2018 | amartineck
I have a GSM1 that when try to zero it, it stops with the "Timeout waiting for spindle up" message. To get thsi up and running, I have set all my machine settings to default and had to reselect the head from a C4 1 head to the flex head. I initially
Electronics Forum | Wed Nov 03 12:57:28 EDT 2010 | adrianam
I need some help with the following alarm appeared on Fuji FCP4-3 : ,,Servo Amplifier alarm on X, Y, C, Z axis". When I push the reset button, remain ,,Servo Amplifier Alarm on D, F theta axis". All the sensors and solenoid it were checked and is OK
Electronics Forum | Sun Jul 11 21:10:27 EDT 2010 | fujiphil
First, check the sensors for 17th and 19th station....tune the sensor amplifier if necessary. Then, check the dogs on the nozzle holders... If the above, items are ok... check the 13th station clutch engagement. Calibrate if necessary... fujiphil
Electronics Forum | Tue Jul 13 10:51:55 EDT 2010 | muarty
Sounds pretty much like the sensors/amplifiers need tuned on your machine. It is a fairly straightforward exercise to do this. The sensors basically look at the back of the chucks to determine which nozzle is in the lowest position and therefore whic
Electronics Forum | Wed Mar 07 19:07:36 EST 2018 | magergar
I have changed the FRQ Amplifier with the FQ amp that has the same parameters and the error persist, the Zero Setting Sensor and the Clutch Origin sensor are working too. Any other posibility?
Electronics Forum | Wed Nov 28 07:44:33 EST 2001 | stefwitt
Justin, you will find measuring equipment at http://www.omega.com All sensor signals are in uV or mV and require a signal amplifier. If you get an amplifier with display, you can program a conversion factor for mV to board stretch and it will show a
Electronics Forum | Thu Jul 18 00:08:31 EDT 2019 | mk15
hank you for the tips. MOT boards have already changed. The sensor on the conveyor responds. In service mode, the WIDTH MOTOR - OK, HOLD MOTOR - OK, SET CONVEYOR - OK, only error TRANSPORT - F-MOT-MSETDYN conveyor transport / 1250: amplifier DC-link
Electronics Forum | Wed Mar 02 05:02:46 EST 2005 | prabhu_jude
Hello, We are using a film piezo electric sensor to deduct and measure vibrations. A long twisted pair shielded cable is used to connect the sensor to the signal conditioning unit (the signal conditioning unit has to be kept at a distance from the se
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
