Electronics Forum: water born conformal coating (Page 1 of 8)

Un-cured conformal coating

Electronics Forum | Fri Oct 29 09:08:21 EDT 2004 | davef

Electrochemical migration under conformal coating: That's possible. Very few conformal coatings are water resistant. So, if you have ionic material on your board, standback. Uncured material under several IC: Materials like yours need moisture fro

Problem with conformal coating

Electronics Forum | Thu Feb 17 10:33:53 EST 2005 | Frank R.

I use conformal coating DYMAX #984-LVUF and I don't know if it's a problem of viscosity but 0805 components are not covered properly. We use a dispensor to applied it and we cured it by UV. Even if I apply a thicker layer, the coating seems to have

Problem with conformal coating

Electronics Forum | Sun Apr 10 03:25:35 EDT 2005 | Peter

Normally, some conformal coatings do not have very good wetting properties, that should be basic function of a good coating material (the same reqirement as avoid bubbles during coating process)! For UV curing conformal coatings, you can try Lackwe

Re: conformal coating selection

Electronics Forum | Tue Nov 28 13:21:33 EST 2000 | Graham Naisbitt

Terry The SCC3 product is a vinyl modified silicone. It is less able to perform at low temps as it becomes brittle. It is not easy to repair because it is essentially silicone. It is not a qualified material to the MIL-I-46058 Spec. Are you sure yo

Ink marking under conformal coating

Electronics Forum | Mon Jul 16 07:10:09 EDT 2012 | mccabekev

I have found that Edding do an aerospace marker, which is water based and does not run with the conformal coating. However, this washes off prior to the coating so it is not much use. Looks like we are just going to have to put some clear tape over

Mixing conformal coating and RTV

Electronics Forum | Thu Apr 21 11:43:03 EDT 2005 | davef

We understand the problem of trying to coat over RTV. We have seen the same problem with acrylic and urethane coatings not wanting to stick to RTV. Some acrylics seem to be worse than urethane. Since this is a new product, may be you could pot your

conformal coating over inspection stamps

Electronics Forum | Thu Jun 27 08:47:21 EDT 2019 | SMTA-John

Having success with Circuit Boards #432 Solvent Resistant Ink - Designed specifically for circuit boards. This medium dry ink is highly resistant to solvents .... It is also non-conducting. Note: this ink contains an aggressive solvent so should not

Conformal coating

Electronics Forum | Tue Feb 10 13:59:29 EST 2004 | Vadim

At times the orange peel effect can be from excess flux improperly removed. Our company strictly provides the service of selctive conformal coating application. We quite often see this. Most times if the board is simply "water washed", or IPA washed,

Conformal coating

Electronics Forum | Tue Feb 10 14:02:03 EST 2004 | Maryann

At times the orange peel effect can be from excess flux improperly removed. Our company strictly provides the service of selctive conformal coating application. We quite often see this. Most times if the board is simply "water washed", or IPA washed,

Bubbles in conformal coat

Electronics Forum | Wed Sep 02 11:36:22 EDT 2009 | kpm135

Is this an established process that is just now exhibiting these problems, or is this a brand new process you're just setting up? What is the rest of your process like? What is done to the boards before you coat them? Water washed? Solvent washed? Sa

  1 2 3 4 5 6 7 8 Next

water born conformal coating searches for Companies, Equipment, Machines, Suppliers & Information