Electronics Forum | Mon Jun 12 11:07:17 EDT 2000 | Jason
after reading some other problems i can tell you that we have an electrovert wave and are using alcohol base flux with convection preheaters. also we are spraying it on...not foaming. we are using an omega wave also. thanks again...if you need mor
Electronics Forum | Tue May 17 10:11:54 EDT 2005 | russ
I would use a foam fluxer since spraying rosin will make the stickiest nastiest mess you can imagine. 18 layer board huh? You will want convection preheat, both top and bottom preheaters, preheat tunnel of at least 4-5', a chip wave, laminar flow w
Electronics Forum | Mon May 14 08:53:42 EDT 2007 | realchunks
Can't do much better than Electrovert. http://cgi.ebay.com/SPEEDLINE-ELECTROVERT-ULTRAPAK-445-16-WAVE-SOLDER-MACH_W0QQitemZ220111865148QQihZ012QQcategoryZ58293QQssPageNameZWDVWQQrdZ1QQcmdZViewItem
Electronics Forum | Fri Jun 19 14:57:00 EDT 1998 | Chris Jackson
I am looking for alternate suppliers of Hollis wave solder fingers other than Speedline(Electrovert) The Model and S/N of the wave solder is Model 207944 Serial # F11132 Please let me know if you are a vendor or know of a vendor. Your help would be
Electronics Forum | Mon Jun 22 21:46:33 EDT 1998 | Dave F
| I am looking for alternate suppliers of Hollis wave solder fingers other than Speedline(Electrovert) The Model and S/N of the wave solder is | Model 207944 | Serial # F11132 | Please let me know if you are a vendor or know of a vendor. Your help w
Electronics Forum | Mon Jun 12 10:57:51 EDT 2000 | Jason
I am new to wave soldering. Any information is greatly welcomed. Here is the problem. After soldering the boards they have a film on the bottom of them and sometimes a white powder looking substance. I have tried decreasing the amount of flux on
Electronics Forum | Fri Jun 12 11:15:50 EDT 1998 | Ryan Jennens
Hey all! The wave solder warrior is back. I have found a flux which leave almost no residue (the least yet), but because of its super low solids content I absolutely cannot get topside fillets. The multi-layer, two sided board is on a pallet w
Electronics Forum | Mon May 14 17:06:41 EDT 2007 | russ
You can get a nice used electrovert in your budget.
Electronics Forum | Mon May 14 13:56:54 EDT 2007 | jdumont
Agreed, I just bought a Electrovert Vectra Elite and have been very pleased with it thus far. I got the dual pot option for lead free changeovers and that has worked great. I can change pots in under 5 minutes, not counting the time to warm up.
Electronics Forum | Thu May 17 09:00:51 EDT 2007 | bsteffen
Since your budget is between 25 and 30K I would say you have plenty of options. Electrovert and Vitronics are both good solid machines. Seho is another option. Seho is extremely user frendly and maintenance freindly and easy to profile however, it is
.gif)
