Electronics Forum | Tue Oct 11 11:52:58 EDT 2005 | chunks
Elektrobit (JOT) makes a wave unloader you can use to put your board back onto an edge conveyor (if you are using just a belt on your oven now) and then place a FIFO or Mag Loader after that.
Electronics Forum | Sun May 09 06:34:53 EDT 2004 | alex
i want to know that friends what is the angle of conveyor in wave soldering machine to get good soldering , can we adjust angle
Electronics Forum | Mon May 10 20:16:02 EDT 2004 | wdlau
it can adjusted per the machine and your boards, Not a fix for every board, also if you are talking about the LF wave soldering process, it should be moved to largr angle compared to the tranditional sn/pb soldering
Electronics Forum | Wed May 12 09:57:32 EDT 2004 | loz
Can you advise why the angle would need to be larger for LF process? Thanks loz
Electronics Forum | Mon May 10 07:53:30 EDT 2004 | pjc
most machines have fixed angle of 6 deg. some are adjustable from 5 - 7 deg., but 6 is most popular.
Electronics Forum | Wed May 12 07:34:42 EDT 2004 | RLeonard
The standard machine is set from the factory at 7-9 degrees, 7 is the most standard, why are you considering the change? before doing any thing to the machine, first identify why? what type of defects are you seeing? I have found, depending on the t
Electronics Forum | Tue May 17 10:11:54 EDT 2005 | russ
I would use a foam fluxer since spraying rosin will make the stickiest nastiest mess you can imagine. 18 layer board huh? You will want convection preheat, both top and bottom preheaters, preheat tunnel of at least 4-5', a chip wave, laminar flow w
Electronics Forum | Wed Jul 15 03:17:47 EDT 2020 | wellmanrau
We have been producing the SMT machines and intelligent equipment for many years, integrated Design, R&D, Production, Sales and Technical Service. What products we manufactured are: SMT Printer/Stencil Printer/Solder Paste Printer, Pick and Place Mac
Electronics Forum | Thu Jul 27 08:02:55 EDT 2000 | Jason
Hello once again! I am having a problem with a 24 pin connector bridging on the wave. We use very similar connectors on other PCB with zero problems. This connector bridges in the same place on the same pins. It forms like a little block of four
Electronics Forum | Thu Nov 20 18:57:52 EST 2014 | warwolf
I can only say it looks okay for what you need, you will want a dual wave system it can make things so much easier. One thing to check would be the wave nozzle sizes I can see that the conveyor will do up to 15" but thats not to say the nozzle is
.gif)
winsouce.jpg)