Electronics Forum | Thu Jan 09 19:55:14 EST 2014 | padawanlinuxero
Hello! I have a problem with one of the products here, we use a pallet to run the board on the solder wave, when the board gets solder and you inspect the board you notice that for some reason the first pcbs that touches the wave are ok, even a litt
Electronics Forum | Mon Jun 12 10:57:51 EDT 2000 | Jason
I am new to wave soldering. Any information is greatly welcomed. Here is the problem. After soldering the boards they have a film on the bottom of them and sometimes a white powder looking substance. I have tried decreasing the amount of flux on
Electronics Forum | Fri Jun 12 11:15:50 EDT 1998 | Ryan Jennens
Hey all! The wave solder warrior is back. I have found a flux which leave almost no residue (the least yet), but because of its super low solids content I absolutely cannot get topside fillets. The multi-layer, two sided board is on a pallet w
Electronics Forum | Mon May 07 12:04:59 EDT 2007 | patrickbruneel
Jerry, If you�re sure your board has sufficient flux it must be that your slow flowing (single lambda) wave produces more oxides then the flux can handle. Due to the conveyer angle the front of the board usually has less flux then the back of the bo
Electronics Forum | Thu Feb 26 16:49:57 EST 1998 | specnor tecnic corp
we have some rebuilt wave soldering systems in stock ready to be shipped. epk-ii smt with lambda wave, chip wave ,omega wave. 4 preheaters,jacking stand roll out computer control. machine is in a great shape. another machin upk15f with 6 preheaters
Electronics Forum | Thu Feb 13 08:28:47 EST 2003 | pjc
Call 1-800-737-8110 for tech support. They can give you the N2 supply specs for the 650C. You should consider the cost to convert the Contour to a standard Lambda vs. the cost to bring in N2 and the consumable costs. Tech Support can give you the ret
Electronics Forum | Thu Feb 20 00:51:42 EST 2003 | Joe
We are running an RMA flux (Kester 1515). Changing the angle didn't help any so we're back at 6 degrees and placing an order for the lambda nozzle changeover. Are you currently running the debridging knife?
Electronics Forum | Sat Feb 15 15:39:53 EST 2003 | Joe
I have the identical machine and setup as you with the same issue(s). I looked at setting up for N2 but am choosing to retrofit to a standard lambda nozzle setup. If you are soldering bottom side SMT parts or other challenging assemblies, N2 may ma
Electronics Forum | Fri Jun 02 11:07:45 EDT 2017 | soldertraining
I think SEHO GoWave 1030 is better than ERSA ETS 330. The SEHO GoWave 1030 is a powerful soldering system for mass soldering applications. It's used for all types of soldering.
Electronics Forum | Tue Nov 22 10:36:23 EST 2005 | maforni
Does anyone know if there are specific tools designed to remove fingers from the wave solder rails? Thanks
.gif)