Electronics Forum | Wed Oct 21 13:50:50 EDT 2020 | kierantennant
hi, I am experiencing a problem with our wave solder machine where zone 2 (forced convection) fan will not work when called upon. so we swapped it with zone 3 to make sure the motor was not at fault and it wasn't so we moved the A1 into a different 2
Electronics Forum | Wed Feb 06 02:14:43 EST 2008 | mun4o
Hi, we use Vitronics Delta 6622 solder wave.I try to adjust high of backplate, but I don't know whether the adjustment is correctly.Now, when the frame enter in the main wave, solder flow in the same direction as PCB.But when the frame go above main
Electronics Forum | Tue Sep 17 13:58:56 EDT 2013 | smtventasmex
i have a vitronics Delta 6622CC with a software fail, i turn it on and when i open the software on the CPU, it enter but show me a message of wrong vertion, and then i choose ok and software close it self, let me know if some one of you have this fai
Electronics Forum | Fri Jun 15 12:07:13 EDT 2018 | fern
My company is hooking up a delta max wave solder machine but we can seem to get the estop error to go away any one have a any experience with this issue.
Electronics Forum | Tue Sep 15 13:02:55 EDT 2009 | horvath83
What do you think about optimal setup for 8-hour working shift and 16-hour standby time. What is the most energy efficient setup for standby time? Complete cooldown or maintaining temperature in solder pot?
Electronics Forum | Mon Dec 17 02:08:21 EST 2007 | mun4o
Hi, I have a lot of solder bridge in our wave soldering process.We use SACX0307 and Surf 11 flux.the SW mashine is Vitronics delta 6622.Itry to change flux and termoprofile but results is not god.Can you halp me - recommend me some flux or other adv
Electronics Forum | Mon Oct 19 05:16:56 EDT 2015 | florintoma
Hello all, I have a problem with the wave 6622c . The temperature of solder pot and preaheating zones 1 and 2 is not increasing. the strange thing is that the machine is not display no error. Can you help me with some advices?? regards
Electronics Forum | Tue Oct 20 10:14:59 EDT 2015 | aemery
Florin, Not sure if this will be helpful or not, but I have completed a couple of pot height retrofits for these waves and I seemed to remember that one of my clients spilled some solder and shorted out the 24vdc power supply. I am pretty sure this
Electronics Forum | Thu Jun 25 09:52:06 EDT 2015 | byviko
Hello, we will buy new wave soldering machine . Trying to decide between two model; Soltec Delta-x and ERSA Powerflow N2. Could you help us , which one is better? most of pcb low volume, others high volume. At first low batch production will be done
Electronics Forum | Mon Jun 29 07:17:25 EDT 2015 | donlockard
Seho maxi wave 3240 should be considered as well. Invented full tunnel nitrogen systems that have lower operating costs and provide yields unlike what can be achieved by air wave systems.
