Electronics Forum | Tue Jan 29 13:51:24 EST 2008 | bbarton
Dave F....BOGUS BOGUS BOGUS What compatability issue could there possibly be if the flux is removed during wash???? Why on EARTH would you leave ANY WS flux residue on the board? A recipie for disaster! Beef up the cleaning process, test for contami
Electronics Forum | Mon Jan 21 11:12:20 EST 2008 | davef
Just what is delaminationg during testing? Water washing should be sufficient to clean WS609. On the other hand, it's possible you're conveyor speed is too high to do a good job cleaning the high density areas. What kind of testing have you done to
Electronics Forum | Sun Feb 03 16:50:59 EST 2008 | bbarton
Won't argure with you Davef, but guys who suggest totally unnecessary steps to resolve a cleaning problem drive me NUTS!! What would the moulding compound manufacturer have to do with it? HIS BOARD IS NOT CLEAN!! Keep it simple, get the job done! Don
Electronics Forum | Tue Jan 29 19:47:36 EST 2008 | davef
Bruce Barton: We're not intending to suggest that anyone is purposely leaving WS flux residue on the board after cleaning. Fact is, Arun isn't sure if the boards are completely clean. Arun said, "We haven't tested the substrate for cleanliness." Gi
Electronics Forum | Fri Oct 08 07:27:23 EDT 2004 | RON Z.
What is wonder solder.
Electronics Forum | Fri Oct 08 08:28:27 EDT 2004 | davef
Wonder Solder [ TRT-Wonder.com ] is a proprietary silver solder. Some cynics might say Wonder Solder got its name because the people that started the firm wondered if anyone was crazy enough to pay that much for solder. Most audiophile silver solde
Electronics Forum | Tue Jun 07 05:21:35 EDT 2011 | lisalau
Can anybody tell me what is a Tray Unit?Who can show me a picture indicating the place of the Tray Unit? Thanks thanks!!millions of thanks! Lisa
Electronics Forum | Tue Jun 07 10:45:17 EDT 2011 | davef
For pictures of a tray unit: * Go here http://eam.go-dove.com/salefiles/2313/2313_577.pdf * Scroll to Page 3 * Page down to the bottom of the page ... there are two pictures of placement machines with tray units attached Here's another unit that's
Electronics Forum | Sat Dec 10 14:20:32 EST 2005 | adlsmt
I have seen a similar problem once about 15 yrs ago. Someone decided to try a water wash flux for tinning wires. Bad idea! The wires were dipped in the flux, then in a solder pot. As the lead tin's it forces the flux in the strands to move up the wir
Electronics Forum | Wed Dec 07 12:28:37 EST 2005 | PWH
I have seen problems similar to this caused by too high concentration of cleaning solution used in ultra-sonic cleaning process. If cleaning solution is used, make sure it is compatible with solder process. Also, improper mixing of fluxes and solde
.gif)
