Electronics Forum | Thu Mar 11 21:36:51 EST 2010 | davef
Poor man's approach to assessing coplanarity issues: * Get two pieces of 2X4 wood that are the same length, about three inches long * Cut the end of one of the pieces at a 45* angle, so that the 45* angle cut leaves a face on the four inch side of th
Electronics Forum | Tue Feb 25 14:42:28 EST 2003 | MA/NY DDave
Hi UNCLE!!! UNCLE!!! You know maybe I do remember this term, yet it is so long ago it doesn't ring a clear bell. From the stuff you passed over it had to come from the electrical technicians and engineers. Bare Boards was a more common term in m
Electronics Forum | Thu Feb 27 15:13:35 EST 2003 | stockley
Oh dear, I tried not to respond but i couldn't help myself. Stop me if I go off into the woods. My guess, Chris, based on your fleeting reference to GF files, is that your SMT machines are Siemens Siplace. If this is so then package orientation def
Electronics Forum | Tue May 23 20:44:13 EDT 2000 | Dave F
Sal: You and Wolfgang are spot on, but let's see if we can blow this out a bit. Before proceding to rattle on ... � PC Card. A credit card-size computer peripheral that add memory, mass storage, and I/O capabilities to computers in a rugged, compa
Electronics Forum | Sat Jun 23 08:29:04 EDT 2001 | davef
Well, at least I don�t feel so bad that we�re not the only ones going anal on this blankin� cap thing. We�re gunna change process on ever effin wave soldered SMT cap!!! I�m going to off myself!!!! And in about 15 seconds, some doodoo brain is goin
Electronics Forum | Sat Mar 06 08:26:59 EST 1999 | Dave F
| Clarissa, | | We place the parts using two different methods. One is using a Fritsch semi automated pick and place. The other is using a vacuum pen. One of the assemblers said if she just had to choose one, she would pick the vacuum pen. I kn
Electronics Forum | Wed Jul 14 09:26:55 EDT 1999 | Dave F
| | I am examining cut & form PTH component prep equipment to help in our manual PTH insertion process. We need the ability to process both axial & radial with snap-in and stand-off capability. Low volume with the ability to feed bulk, T&R, or Stick.
Electronics Forum | Wed Jul 14 19:09:54 EDT 1999 | JohnW
| | | I am examining cut & form PTH component prep equipment to help in our manual PTH insertion process. We need the ability to process both axial & radial with snap-in and stand-off capability. Low volume with the ability to feed bulk, T&R, or Stic
| 1 |
winsouce.jpg)
