Electronics Forum | Thu Apr 19 20:14:09 EDT 2012 | eadthem
I don't, My desk causally is piled with papers, programming printouts, PCB's with defects to be resolved, and spare/broken parts from the SMT machines. For me its more important to help the SMT department and SMT Inspection department get better or
Electronics Forum | Thu Aug 31 15:27:17 EDT 2006 | Chunks
We use two Streckfuss wave solder machines. They are pretty small depending on your needs. Maybe not the best, but being local and since we use a lot of their forming equipment, it works out well
Electronics Forum | Thu Aug 17 13:55:45 EDT 2023 | markhoch
I think we need more information. Is it moving at all? Does it move to a reference position and then stop before returning to the home position? Have you verified that all sensors are working correctly? Does the machine use stepper motors, motors & e
Electronics Forum | Thu Jun 02 12:44:13 EDT 2005 | russ
Your inspection people will tell you what they need. We have some that prefer to stand while others sit. It has to do with chair / table / operator heights. e.g. tall table with a short operator they will want/need to stand and vice versa. Usuall
Electronics Forum | Sun Apr 07 00:45:21 EDT 2019 | d_nguyen2018
Hi, Can you show me how to set up tray table? I have 1 x 10 pockets tape with 10 PQFPs. I went into Magazines then selected Tray Wagon. I did first and last part on the 1 x 10 tape pockets but it did not work. I was told that I must set up the tray
Electronics Forum | Thu Aug 13 14:43:23 EDT 2015 | alphatronique
HI i try to figure how the "Manual load adapter" work on a T3 Table machine ? seem that the table always try to move the board to the the left sensor location ,but if i use the magnet manual table it will never find the board on the table convey
Electronics Forum | Thu Jul 06 19:41:31 EDT 2000 | Hermie
We recently installed a new Servo-Amp which controls the X-Y table on our CP6 machine. Eversince, we are experiencing a Cycle alarm X-reach on the machine. We tried to greased the table a little bit more but the only thing that seems to work is to sl
Electronics Forum | Wed Jun 12 09:37:13 EDT 2019 | key
We have a Dek 248 that when the table goes in it will not come out. We tested up/down sensors they are fine. The in and out sensors work in diagnostic. when we try to abort the unit the table should come out but doesn't. Any help would be great and a
Electronics Forum | Thu Jan 18 14:58:52 EST 2007 | jhaviland
Another question. Did you also use the table Mirtec provides for the desktop models? They work horribly on even a slightly unstable table, Which is what I have seen. Very outstanding machines but crippled by an employers choice of using a standa
Electronics Forum | Thu Jul 25 14:44:34 EDT 2013 | falvarez
Im needing an Rising table motor for Dek Horizon, but with a 4000 count encoder, because that motor i bought become with a 1000 count encoder and not worked. any suggestion?