Electronics Forum | Mon Oct 17 13:02:28 EDT 2016 | tdemon69
i have a MPM2000 now giving me 0 - hardware limit warnings..let me start off by saying that is was giving me x axis limit problems, so i replaced the x card with diff card. set all the switch and jumpers to x card , then i got 0- hardware . so then
Electronics Forum | Tue May 10 09:45:53 EDT 2011 | veeckm
After changing mod codes 50,51 and 54,55 respectively on the HHT I will then goto ccconfig.sys file in the central controller software and manually enter in the new mod code values. I do not do any uploading/downloading of mod codes through database
Electronics Forum | Thu Jul 07 19:39:18 EDT 2005 | darby
This is a very difficult question to answer as it will depend greatly on your component mix. I will presume that the CSM 84VZ is of the following configuration: 2 x RDC Synchro Heads. Heads 1 & 2. These are mechanically centering heads with a chucki
Electronics Forum | Thu Jul 13 22:20:38 EDT 2000 | Dave F
=10 mils larger than lead 3 silk screen legend text weight >=10 mils 4 pads >=15 mils larger than finished hole sizes 5 place through hole components on 50 mil grid 6 no silk screen legend text over vias (if vias not solder masked) or holes 7 so
1 |