Electronics Forum | Mon Nov 25 02:15:07 EST 2019 | mk15
it is possible to test x belt motor and x wagon motor.
Electronics Forum | Wed Feb 12 14:53:21 EST 2020 | SMTA-Alex
Looks like an X-belt problem. is it tensioned correctly, not too loose or too tight? Or the X motor is acting up.
Electronics Forum | Fri Oct 12 11:21:43 EDT 2018 | tech1
There are 2-X motors and numerous items that could be causing this: 1 of the X motors, 1 of the X transducers, 1 of the couplings connecting the motor and transducer, X Kevlar Belt. If you know how to go into the service portion of the software you
Electronics Forum | Mon Oct 25 11:20:52 EDT 2021 | bk
The 245 error is with your x belt motor not the x wagon motor. double check all the fuses on the back of the machine where your power comes in there should be 3 of them. if you haven't changed your blue cables in a while I would change those out. you
Electronics Forum | Tue Jun 14 15:59:25 EDT 2022 | mikevb
Thanks! I just needed a response like that. I will do all that, and if it's still an issue, I'll change the x wagon encoder right? There are three encoders on the x wagon though? The white one on the x carriage, the white one on the x belt drive mo
Electronics Forum | Mon Oct 05 10:29:38 EDT 2009 | cyber_wolf
I ended up finding that there were broken chords on the X-belt. I replaced it and all is good. Rob, Mydata is right. You can indeed end up spending lots of time and money trying to chase a transducer error. Things I would look at: 1. Lubing the X b
Electronics Forum | Tue Jan 04 13:00:07 EST 2011 | bk
The only x fan i can think of would be the x belt motor fan which is on the back of the black box sticking out of the back of the machine. If it's a heat issue then first thing to do is replace the 2 filters behind the 2 vented covers located on the
Electronics Forum | Wed Feb 12 14:14:42 EST 2020 | alvarez94
I am running a MYDATA MY19 machine.the problem is that the first 2 hours after turning on the machine it does not work throwing the following error: "transducers do not agree". After approximately 1 or 2 hours the machine starts working normally. T
Electronics Forum | Wed Feb 12 15:11:29 EST 2020 | alvarez94
I was consulting the manual of the machine and to measure the tension of the x belt I need a frequency counter and two prisms but I don't have these tools, is there any other way to measure the tension?
Electronics Forum | Fri Nov 22 00:09:29 EST 2019 | mk15
I am looking for some help for where to look to fix this MY15E problem. 1. after hardware initiation appear - F-MOT-MOVE X/250: Motor speed out of control (photo1). 2. in service mode when x motor initiate appear - F-MOT-MSETDYN X/12: No axis movemen