Electronics Forum | Tue Jun 11 10:20:31 EDT 2019 | capse
I'm a Rep for Yamaha equipment. I have several customers using Feeder Finger with great success. The Yamaha feeder has a design feature that compliments the Feeder Finger.
Electronics Forum | Fri Sep 01 22:44:47 EDT 2006 | dmfausti
I have just been engaged again in SMT pick-n-place machines. My latest exposure is with Yamaha YV100 and YM84. I have been having some problem on feeders, especially on 1206 reel packages and above. The plastic cover on the reel does not peel off eas
Electronics Forum | Wed Jul 01 01:25:58 EDT 2020 | jmelson
> I think the main > issue is the bend radius you can apply to tape > with deeper pockets. Right, on my Philips CSM84, on the larger tapes, I don't thread the tape through the return slot, I let it play out the front of the feeder. The
Electronics Forum | Sat Jul 17 10:04:39 EDT 2004 | stefwitt
I think we should shift this issue to the machine suppliers, requesting changes in the machine design, in order to keep at least the jobs of high mix, low volume in this country. We can only compete with low labor cost countries by increasing the lev
Electronics Forum | Thu Nov 29 15:52:53 EST 2007 | jmelson
Some other machines are a lot simpler. Here's how the Philips (mady by Yamaha) CSM84 works. Smaller tape (8 and 12 mm) feeders are all mechanical. A plunger on the head pushes a lever on the feeder at the same time the head comes down. First, the
Electronics Forum | Mon Oct 24 11:04:58 EDT 2022 | richardcargill
The yamaha feeders need leader tape to function - so if you're using cut reel components you'll lose 3 or 4 just on set up alone. Run-time attrition is harder to help with as machine setup and calibration, condition of nozzles/feeders, ability of ope
Electronics Forum | Tue Sep 12 01:54:57 EDT 2006 | AR
I assume that you are referring to the same kind of mechanical feeders (older type) that are used on the Philips (Assembl�on) Topaz as well. First make sure that the right gear pulley spring is set to its stiffest position (the loop at the end of the
Electronics Forum | Mon Oct 24 07:15:53 EDT 2022 | umar
Hi All SMT Expert and Members, Any one can help or share how to set the attrition formula at SMT machine pick and place process, FYI, I had a product with high mix low volume with qty running per model is less than 50 pcs, the pcb and place machi
Electronics Forum | Wed Oct 19 21:51:24 EDT 2022 | rgduval
The only time we dealt with "major" loss related to the feeders was when they were out of maintenance. Kept in good shape, sure there's loss; but, I never considered it to be major. But, that is subjective, of course. In the end, in my mind, it
Electronics Forum | Thu Jul 07 19:39:18 EDT 2005 | darby
This is a very difficult question to answer as it will depend greatly on your component mix. I will presume that the CSM 84VZ is of the following configuration: 2 x RDC Synchro Heads. Heads 1 & 2. These are mechanically centering heads with a chucki