Electronics Forum | Thu Nov 10 18:58:38 EST 2005 | darby
What is the problem Peter? See a recent posting on a Y axis problem with the same style of machine. If the encoder is cactus, buy a new motor. Sorry, this is the only solution I know of.
Electronics Forum | Tue Oct 25 09:20:10 EDT 2005 | meritajs
Hi, We have problem with y-axis offset at YM84 After setting the ORIGIN machine operate exactly but after sometime y-axis recieves offset bis 5-10mm.After repeated setting ORIGIN Y-coordinat became exact. The same things take place if we operate in W
Electronics Forum | Thu Oct 27 03:15:14 EDT 2005 | Jeff Roberts
The Y-axis motor of the YM84 Series is well known for failures. The bearing between the encoder and the armature fails causing dirt to fall on the encoder wheel, hence the encoder mis-counts. If you re-Origin the machine the problem is resolved for a
Electronics Forum | Wed Oct 26 03:43:11 EDT 2005 | meritajs
Hi Ken, Thank for your advice We suppose that with home position all is OK and ratio is in interval 40-60%.Y axis offset is not constant 5mm or 10mm but change ratio with working time and may be more than 10mm We think that problem is with Yservo mo
Electronics Forum | Wed Oct 26 18:25:13 EDT 2005 | darby
The encoder on the Y axis motor is almost certainly kaput. Debris from the wear of the motor brushes or whatever else can find its way onto the encoder and give an ever increasing false pulse. The axis will start OK but progressively go out of whack
Electronics Forum | Wed Oct 26 21:44:42 EDT 2005 | KEN
If your sure your drive lines are staying put then it must be the motor. ... odd no servo feedback alarms though. That's why I thought problem might be mechanical. Does the yv84 use servo's? IF yes, then no brushes to wrory about. Don't bother t
Electronics Forum | Thu Sep 24 00:52:41 EDT 2015 | ermani9
Hi.. Move the XY arm to the center of the machine. Turn on the servo then immediately hold “LOWER” then press “ORIGIN”. You should see the message now on the screen “DRIFT CHECK”. The arm will start to drift without an emergency condition occurr
Electronics Forum | Wed Nov 09 23:02:34 EST 2011 | jeffr
Tom, I cannot find the software to operate my Sunshine EPROM burner right now. It is safe for you to read out the files on each of the ROMs using your burner. It is just a plug in, plug out operation to get the machine going again. The machine will s
Electronics Forum | Thu Oct 04 00:05:25 EDT 2018 | gaintstar
Flason SMT chip mounter Reflow Ovens: http://www.flason-smt.com/product/PCB-assembly-line-equipment-SMT-spare-parts-Dek-Motor-188962.html http://www.flason-smt.com/product/PCB-Conveyor-for-LED-Production-Line-SMT-Assembly-Line.html http://www.flason-
| 1 |
.gif)
