Electronics Forum | Thu Sep 19 21:46:01 EDT 2002 | scottefiske
In the past year I was responsible for developing and leading a Team focused on AOI, Evaluation, Justification, and with a full ROI required, supporting a HMLV manufacturing environment. If you have in these economic times the additional resources t
Electronics Forum | Thu Aug 02 15:06:03 EDT 2018 | jeffallen662
They where bought directly from YesTech and were guaranteed to be programmed from YesTech.
Electronics Forum | Thu Aug 02 09:14:17 EDT 2018 | jeffallen662
Hey I'm having some issues with a YesTech YTV-1000 AOI machine. The machine isn't recognizing the X and the Y stepper motors. As far as we can tell nothing mechanical is wrong with the AOI. They are new motors and were suppose to have been programmed
Electronics Forum | Thu Aug 02 10:48:29 EDT 2018 | dleeper
I'm going off fuzzy memories for a YTV-2000 but its probably not too different for the 1000... The motor drivers need to be configured for the specific axis they are driving. This should have been done by Yestech before they shipped them to you. If
Electronics Forum | Thu Aug 02 14:10:55 EDT 2018 | jdengler
Could they be on the wrong axis from what they are configured for (X and Y swapped)? Jerry
Electronics Forum | Fri May 27 11:12:04 EDT 2005 | Ray
We have switched from Uniscam due to support issues and their ablity to come out with a new USABLE version. We have been running it for close to 2 years now and we have been extremely happy with its performance and their support. Version 6.0 which
Electronics Forum | Fri Jan 25 14:06:05 EST 2008 | brulal1
Thank Brian we will contact them
Electronics Forum | Thu Jan 24 21:02:40 EST 2008 | bdamico
Hello Bruno, Please contact our Technical Support Staff at (203) 881-5559. We will be more thatn happy to assist you. Thank you, Brian D'Amico President MIRTEC Corp
Electronics Forum | Wed Jan 23 09:38:37 EST 2008 | brulal1
I would like to get statistic from SPC plus on regular basis, the problem is: Software is slow and freezing. The only stat I could get from it are general. The nigthmare start went we try to dig to find what cause the defect. It�s possible, but it ai
Electronics Forum | Fri Jul 24 16:45:28 EDT 2015 | cnotebaert
Parmi & yestech are great machines, Mirec is pretty good too,,, But I've had software and support issues with them in the past.. very painful to work through software issues/upgrades with.
