Electronics Forum | Fri Oct 04 14:15:21 EDT 2019 | ddfreeze
that doesn't seem to be the issue here
Electronics Forum | Thu Oct 03 18:00:51 EDT 2019 | ddfreeze
Got a used mpm up2000. It gives z axis hardware limit warning when trying to teach vision. The board raises to camera then drops back down. However when loading a board for tooling, the board stays raised up. The z table can be manually raised up n d
Electronics Forum | Fri Oct 04 13:47:25 EDT 2019 | compit
I had as I placed the supports at the back - when lifting Z touched the rear rail - check.
Electronics Forum | Wed Dec 04 08:02:02 EST 2019 | proceng1
Contact George Castonguay at PPM. He is a Jedi when it comes to these machines. In fact, since you just got it, a good investment would be to have George come in and go through the machine and get it calibrated. 603-895-5112 They also sell parts
Electronics Forum | Fri Feb 19 11:17:29 EST 2010 | kpm135
When I try to load a board in our MPM UP2000 HiE I get the following error "Z axis software limit". The Z axis will move up and down freely, I re-calibrated it and reprogrammed the board and the error continues. Has anyone else run into this issue an
Electronics Forum | Mon Feb 22 10:19:57 EST 2010 | swag
Check/reseat all connections on axis driver card and from driver card to step motor. On older MpM's it is common to get a bad connection on the connector for axis driver power and blow components on your driver board. Reseating these connectors mig
Electronics Forum | Sat Oct 18 22:41:54 EDT 2014 | pfifla1
Can't help you with the manual but do have some > tips: If it was shipped, it's possible someone > tied axis or blocked stuff for shipping. Look > for that. Look for bent sensor flags + go into > I/O and check to see all sensors you can find a
Electronics Forum | Tue Oct 14 10:52:35 EDT 2014 | swag
Can't help you with the manual but do have some tips: If it was shipped, it's possible someone tied axis or blocked stuff for shipping. Look for that. Look for bent sensor flags + go into I/O and check to see all sensors you can find are working.
Electronics Forum | Sun Oct 12 22:08:34 EDT 2014 | cusackmusic
I just got a used AP/C which I guess is also called an AP25? After fixing a few obvious issues, I powered it up, and get a hardware limit error. I have verified that none of the axis are near their limits. Without a manual, I'm not sure where to go
Electronics Forum | Tue Aug 04 14:43:12 EDT 2009 | kpm135
Thank you very much SWAG that password did the trick. Got us into the calibration menu and we were able to calibrate the z-axis and snugger height and got it to work. Thanks again
