PCB Libraries, Inc. | https://www.pcblibraries.com/forum/RSS_surface-mount-connectors_topic1872.xml
: Surface Mount Connectors Surface Mount Connectors : IPC-7351C does not support the... Author: Tom HSubject: 1872Posted: 13 Apr 2016 at 7:33amIPC-7351C does not support the auto-calculation of SMD connectors from bent terminal leads
| https://www.eptac.com/ask/gullwing-lead-deformation/
% of the diameter, width, or thickness of the lead.” So if the leads are damaged or bent more than 10% of the diameter, width, or thickness of the lead, they cannot be used
| https://www.eptac.com/faqs/ask-helena-leo/ask/gullwing-lead-deformation
. Exposed basis metal is acceptable is deformation does not exceed 10% of the diameter, width, or thickness of the lead.” So if the leads are damaged or bent more than 10
| https://www.eptac.com/faqs/ask-helena-leo/ask/j-std-001e-2010-4-5-1-gold-removal-issues
? Does this mean we should remove the ICs from their tape and reel packaging, tin the leads for proper gold removal, then re-reel the parts for proper packaging for pick and place equipment
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/RSS_axial-components-pitch-calculation_topic1896.xml
) the requirements of the lead forming machine.Note that the leads must NEVER be bent by holding the body. They are always bent by clamping the lead and applying the bend on the non-body side of the clamp
| http://etasmt.com/te_news_bulletin/2019-08-05/9161.chtml
vapor phase reflow soldering. The reason for such defects is usually caused by the fact that the thermal conductivity of the relevant component leads is too high, and the temperature rises too fast, which causes the upturn of the
1st Place Machinery Inc. | http://www.firstplacemachinery.com/first_place_smt_pcb_aoi_mvp.html
. System can inspect SMT components pre-or post solder for presence / absence and placement verification (x,y,and theta ) polarity, solder fillet, bridging, solder opens, insufficient fillets, excess solder, and lifted leads
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/topic1872&OB=ASC.html
: 5376 Post Options Post Reply Quote Tom H Report Post Thanks(0) Quote Reply Posted: 13 Apr 2016 at 7:33am IPC-7351C does not support the auto-calculation of SMD connectors from bent terminal leads. Most connector mfr
ASYMTEK Products | Nordson Electronics Solutions | https://www.nordson.com/en/divisions/yestech/about-nordson-yestech/articles/combining-2d-and-3d-aoi-the-most-effective-inspection
. The primary advantage of 3D inspection over 2D inspection is that it provides true volumetric height information. Coplanarity on lifted leads and other height-sensitive devices can be detected without difficulty