| http://etasmt.com/cc?ID=te_news_industry,23962&url=_print
. Also, low solder volume can cause solder defects. Is the stencil designed for the PIP process? To get enough paste to fill up the pin hole, the stencil aperture must be designed bigger than the solder pad size depending upon the paste volume calculation
| http://etasmt.com/te_news_bulletin/2019-12-26/13361.chtml
. We found that an average total heating time of 4 to 4½ minutes (240-270 seconds) is a good, relatively conservative estimate. For this simple calculation, we recommend that you ignore the cooling part of the welded profile
| http://etasmt.com:9060/te_news_industry/2021-08-31/23962.chtml
. Also, low solder volume can cause solder defects. Is the stencil designed for the PIP process? To get enough paste to fill up the pin hole, the stencil aperture must be designed bigger than the solder pad size depending upon the paste volume calculation
| http://etasmt.com/te_news_industry/2021-08-31/23962.chtml
. Also, low solder volume can cause solder defects. Is the stencil designed for the PIP process? To get enough paste to fill up the pin hole, the stencil aperture must be designed bigger than the solder pad size depending upon the paste volume calculation
| http://etasmt.com/cc?ID=te_news_industry,24361&url=_print
= Oven chamber heated length Process dwell time Below is an example of calculation to establish the correct oven size:- An SMT assembler wants to produce 8-inch boards at a rate of 180 per hour
| http://etasmt.com:9060/te_news_industry/2021-09-01/24361.chtml
= Oven chamber heated length Process dwell time Below is an example of calculation to establish the correct oven size:- An SMT assembler wants to produce 8-inch boards at a rate of 180 per hour
| http://etasmt.com/te_news_industry/2021-09-01/24361.chtml
= Oven chamber heated length Process dwell time Below is an example of calculation to establish the correct oven size:- An SMT assembler wants to produce 8-inch boards at a rate of 180 per hour
ASYMTEK Products | Nordson Electronics Solutions | https://www.nordson.com/en/our-company/news-room/news-releases/nordson-corporation-reports-2013-fourth-quarter-and-full-year-results
effects of currency translation. Fourth quarter operating profit was $87 million, net income was $60 million and GAAP diluted earnings per share were $0.92
ASYMTEK Products | Nordson Electronics Solutions | https://www.nordson.com/en/divisions/polymer-processing-systems/information/mitigating-and-troubleshooting-pelletizing
plate, the throughput rate, and the pellet weight. The calculation is below: The number of open holes = (16.67 x production rate (kg/hr)) / (weight per pellet (g
ASYMTEK Products | Nordson Electronics Solutions | https://www.nordson.com/en/our-company/news-room/news-releases/nordson-corporation-reports-fiscal-year-2015-third-quarter-results
Fourth quarter 2015 GAAP diluted EPS guidance expected in the range of $1.00 to $1.12, inclusive of a $0.01 per share short term purchase accounting charge related to the step-up in value of acquired inventory
winsouce.jpg)