1st Place Machinery Inc. | http://www.firstplacemachinery.com/firstplace_plastics_robots_star3.html
. press range: typically 150 ton to 300 ton depending on application. delivery: set up for non-op side but can be changed Star Automation for injection molding machines
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/RSS_3d-model-plated-through-lead-length_topic2655.xml
:45amHello,Is it possible to control the length of leads? Depending on the board thickness, there are occasions were the lead on the step model does not protrude the board.
| https://www.eptac.com/soldertips/soldertip-45-manual-soldering-vs-wave-soldering/
. The second part of this is volume. A manual solder joint takes about one to three seconds to make, plus depending upon the flux type used must be cleaned
Precision PCB Services, Inc | https://precision-pcb-services-inc.com/products/bga-reballing-service
. Price varies depending on chip size and quantity. Please call for a quote: (888) 406-2830 Share 0 Share on Facebook Tweet Tweet on Twitter Pin it 0 Pin on Pinterest Fancy Add to Fancy +1
Precision PCB Services, Inc | https://precision-pcb-services-inc.com/products/gold-finger-repair
. Price varies depending on size and quantity. Standard price to replace a Gold Finger Contact is $50.00 each. Call (888) 406-2830 for a free quote
Precision PCB Services, Inc | https://precision-pcb-services-inc.com/products/pcb-rework-services
. We repair surface mount pads, BGA pads, Gold Finger Contacts and other circuitry. Price may vary depending on quantity, type of pad and degree of damage
GPD Global | https://www.gpd-global.com/co_website/pdf/pump/Two-Part-Mixing-Pump.pdf
0.05 ml/revolution Smallest Dispensing Shot 0.005 ml / 5 µl 0.01 ml / 50 µl Syringe Sizes Standard 10-55 cc * depending on medium and configuration
GPD Global | https://www.gpd-global.com/pdf/pump/Two-Part-Mixing-Pump.pdf
0.05 ml/revolution Smallest Dispensing Shot 0.005 ml / 5 µl 0.01 ml / 50 µl Syringe Sizes Standard 10-55 cc * depending on medium and configuration
| https://www.eptac.com/ask/soldering-covers-to-a-housing/
. We are hand soldering the lid in place on the cover, filling the seam between the housing and cover with solder. At times we use SN 96 and other times SN 63 solder depending on how the customer will future process the units
Imagineering, Inc. | https://www.pcbnet.com/blog/understanding-the-importance-of-pcb-testing/
) In-circuit testing is the most highly utilized PCB testing method for its accuracy and specificity to each PCB product. Depending on the end-use of your PCBs each one or some in each batch will be tested
