GPD Global | https://www.gpd-global.com/pdf/dispense/ClearVu-Vision.pdf
. During program operation with ClearVu™Vision, many parameters can be adjusted on the fly: Zoom, Focus, Illuminator Color, as well as camera gain and offset. FLOware®
GPD Global | https://www.gpd-global.com/co_website/pdf/doc/Cyclops-II-Vision-Software-InstallUpdateRestore-Guide-22240108.pdf
software Jog window where an image should appear in the display area. The Jog window settings for camera lens gain and offset may need to be adjusted. 3/10/21 GPD Global®
GPD Global | https://www.gpd-global.com/pdf/doc/Cyclops-II-Vision-Software-InstallUpdateRestore-Guide-22240108.pdf
software Jog window where an image should appear in the display area. The Jog window settings for camera lens gain and offset may need to be adjusted. 3/10/21 GPD Global®
ASYMTEK Products | Nordson Electronics Solutions | https://www.nordson.com/en/our-company/news-room/news-releases/nordson-corporation-reports-2013-fourth-quarter-and-full-year-results
. We’re also encouraged by recent order rates, which began to gain momentum during the fourth quarter.” Fourth Quarter Segment Results
GPD Global | https://www.gpd-global.com/co_website/pdf/doc/FLOware-Software-Guide-Addendum-Deferred-Reverse.pdf
gain (0-255) for dispensed or drilled dot calibration. A value of -1 disables change. Offset Camera offset (0-255) for dispensed or drilled dot calibration. A value of -1 disables change. Tuning Camera tuning (1-1000) for dispensed or drilled dot
GPD Global | https://www.gpd-global.com/pdf/doc/FLOware-Software-Guide-Addendum-Deferred-Reverse.pdf
gain (0-255) for dispensed or drilled dot calibration. A value of -1 disables change. Offset Camera offset (0-255) for dispensed or drilled dot calibration. A value of -1 disables change. Tuning Camera tuning (1-1000) for dispensed or drilled dot
GPD Global | https://www.gpd-global.com/co_website/pdf/lead-former/CF8-Wire-Clamp-Replacement-8201622.pdf
. Correct alignment occurs when the wire clamp is aligned in the same plane as the die (shown below at left), as opposed to the wire clamp being offset to the right or left of the die surface. GPD Global®
GPD Global | https://www.gpd-global.com/pdf/lead-former/CF8-Wire-Clamp-Replacement-8201622.pdf
. Correct alignment occurs when the wire clamp is aligned in the same plane as the die (shown below at left), as opposed to the wire clamp being offset to the right or left of the die surface. GPD Global®
winsouce.jpg)
