| https://www.eptac.com/soldertips/soldertip-48-the-cleanliness-of-wire-and-terminal-connections/
capillary action, to wick beneath the wire insulation where the flux residues will remain without the ability of being cleaned away. As called for in J-STD-001, the fluxes have to be qualified to verify the residual residues are not going to be detrimental to the functional operation of the product
| https://www.eptac.com/soldertip/soldertip-48-the-cleanliness-of-wire-and-terminal-connections/
capillary action, to wick beneath the wire insulation where the flux residues will remain without the ability of being cleaned away. As called for in J-STD-001, the fluxes have to be qualified to verify the residual residues are not going to be detrimental to the functional operation of the product
| https://www.eptac.com/faqs/soldertips/soldertip/soldertip-48-the-cleanliness-of-wire-and-terminal-connections
capillary action, to wick beneath the wire insulation where the flux residues will remain without the ability of being cleaned away. As called for in J-STD-001, the fluxes have to be qualified to verify the residual residues are not going to be detrimental to the functional operation of the product
| https://www.eptac.com/faqs/ask-helena-leo/page/3
. J-STD-001, IPC-A-610 and IPC-A-620 all require solder to be “visible” in the inspection hole (if present). Is there a more specific requirement to this
40731 | https://www.smta.org/harsh/Harsh-Environments-Conference-Program-2020.pdf
Surface Mount Technology Association (SMTA)
0.75 ug/cm2, which converts to 4.4 ug/in2, however; IPC 6012 still has the board cleanliness limit for sodium chloride as 1.56 ug/cm2 (10.06 ug/in2). Read Answer Building to IPC-A-610 or J-STD-001 Question
| https://www.eptac.com/soldertip/soldertip-39-class-2-vs-class-3-assemblies/
: Clean vs No-Clean Fluxes SolderTip #40: Component Mounting and Acceptability SolderTip #41: J-STD-001 Revision E is Here – Order it Now! Question : Can you give me a basic definition of the differences between Class 2 and Class 3 products and where these differences show up in the IPC documents
| https://www.eptac.com/solder-tips/
: Gold Removal and Wave Soldering vs Hand Soldering Question: Regarding gold removal requirement under Section 4.5.1 of J-STD-001, it allows
| https://www.eptac.com/wp-content/uploads/2020/02/eptac_webinar_03-18-20.pdf
. Specification task group committees 6. IPC has 405 document listed on its Revision Table www.ipc.org 1. 375 active and 30 obsolete 2 http://www.ipc.org/ J-STD-001/610 • The 001 and 610 are being updated to Rev H and the comments are being handled at the meetings and through zoom meetings and con calls
| https://www.eptac.com/wp-content/uploads/2021/10/EPTAC_DataSheet_600-CSE.pdf
■ Industry-Demanded Certifications PCB TECHNOLOGY Quality & Inspection ■ IPC-A-610 Instructor & Operator Certification Soldering & Assembly ■ IPC J-STD-001 Instructor
