PCB Libraries, Inc. | https://www.pcblibraries.com/Forum/component-placement-and-courtyard_topic918_post3382.html
Posted: 10 Apr 2013 at 6:59pm It's the courtyard centerline (not the line edge). You can bump courtyard lines so they overlap on top each other
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/topic918&OB=ASC.html
Posted: 10 Apr 2013 at 3:13pm Is the minimum component spacing relative to the outside of courtyard line or the center? Is it ok for the courtyard lines to overlap, if the center of the lines does not overlap
| https://www.eptac.com/wp-content/uploads/2021/11/webinar_eptac_05_19_10.pdf
Check the date, the certificate number and the certification center 8 610 Changes The inclusion of definition of wire overlap and overwrap in sections: 1.5.11 and 1.5.12 and Section 6
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/courtyard-interference-double-sided-pcb_topic509_post1554.html
. When I run the Verify Design tool, clearence violations occur because the courtyards from the Top of the PCB overlap with the courtyards from the Bottom
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/courtyard-interference-double-sided-pcb_topic509.html
. When I run the Verify Design tool, clearence violations occur because the courtyards from the Top of the PCB overlap with the courtyards from the Bottom
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/topic509&OB=DESC.html
If you have a good assembly shop you can touch (bump up) courtyards but not overlap. Just set yout Body to Body Clearance in Setup > Design Rules > Default > Clearance > Body to Body = 0
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/topic509&OB=ASC.html
. When I run the Verify Design tool, clearence violations occur because the courtyards from the Top of the PCB overlap with the courtyards from the Bottom
ASYMTEK Products | Nordson Electronics Solutions | https://www.nordson.com/en/divisions/sealant-equipment/solutions/battery-cell-power-distribution-applications
: Two component curing epoxies Single component epoxies, curing from heat Common Challenges: Long Beads – the length of the bead may exceed the volume of the meter, requiring the meter to reload, resulting of a gap, or overlap, in the bead. Nordson Solution
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/RSS_sip4l-diodes_topic1466.xml
:59amI forgot to mention that the FP Designer can do Oblong through-hole pad shape to avoid pad overlap and still provide a good solder joint. SIP-4L, Diodes
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/to2205-package_topic2432_post10022.html
. All five pads overlap and thus all five leads are shorted together. Also the body outline just doesn't seem right. I tried the vertical mount configuration and the pads for the leads all overlap