PCB Libraries, Inc. | https://www.pcblibraries.com/Forum/3d-model-plated-through-lead-length_topic2655_post10837.html
? Depending on the board thickness, there are occasions were the lead on the step model does not protrude the board. If this is not currently possible, would it be possible to include this in an upcoming revision
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/topic2655&OB=ASC.html
? Depending on the board thickness, there are occasions were the lead on the step model does not protrude the board. If this is not currently possible, would it be possible to include this in an upcoming revision
PCB Libraries, Inc. | https://www.pcblibraries.com/Forum/topic1213&OB=DESC.html
will protrude over the edge of the pad. For the software not to do this, I am forced to insert the normal pin width and only the +tolerance. The -tolerance needs to be
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/topic1213&OB=ASC.html
will protrude over the edge of the pad. For the software not to do this, I am forced to insert the normal pin width and only the +tolerance. The -tolerance needs to be
GPD Global | https://www.gpd-global.com/co_website/pdf/lead-former/CF8-Spring-Plunger-Replacement.pdf
) and install crank pin (PN 801- 1-12). 7. Center crank pin so ends of the pin do not protrude from edge of slide, and then install and tighten set screw. 8
GPD Global | https://www.gpd-global.com/pdf/lead-former/CF8-Spring-Plunger-Replacement.pdf
) and install crank pin (PN 801- 1-12). 7. Center crank pin so ends of the pin do not protrude from edge of slide, and then install and tighten set screw. 8
GPD Global | https://www.gpd-global.com/co_website/pdf/lead-former/CF8-Wire-Clamp-Replacement-8201622.pdf
. Center crank pin so ends of the pin do not protrude from edge of slide, and then install and tighten set screw. 4. Lubricate slide assemblies per standard manual instructions
GPD Global | https://www.gpd-global.com/pdf/lead-former/CF8-Wire-Clamp-Replacement-8201622.pdf
. Center crank pin so ends of the pin do not protrude from edge of slide, and then install and tighten set screw. 4. Lubricate slide assemblies per standard manual instructions
| https://ipcapexexpo.org/exhibitors/event-rules-regulations
in the case of a distributor and/or manufacturer's representative). Signage and Graphics All signage and graphics must stay within the confines of the booth and not protrude into the aisles or into adjacent booths. Any portion of the exhibitor’s booth
GPD Global | https://www.gpd-global.com/co_website/pdf/doc/Dispense-System-User-Guide-22100079K.pdf
requirements to prevent access to the sides of the machine where (1) the con- veyor rails protrude and (2) the cutouts in the safety shielding accommodate the conveyor. CE SAFETY CERTIFICATION: DO NOT alter the machine in any way not specified in this document
winsouce.jpg)
