Heller Industries Inc. | https://hellerindustries.com/wp-content/uploads/2018/06/688951_OvenSetupWizard-XP4021.pdf
. LTO Green On / LTO Green Off - for special light tower operation New job –flashing Green, OK –Green light On or Off, Warning –Yellow, Alarm, board drop / stop warning –flashing Red
Heller Industries Inc. | https://hellerindustries.com/wp-content/uploads/2018/06/HellerSetupWizard-10658.pdf
–Green light On or Off, Warning –Yellow, Alarm, board drop / stop warning –flashing Red. Light tower display shows Green, Red and Yellow from top to bottom. Heat Fan Fault
Heller Industries Inc. | https://hellerindustries.com/wp-content/uploads/2018/06/686047-Win98SE-Software-versions-HC1-controller.pdf
. Belt speed unit conversion fixed. Board stop warning added as feature - if board blocks exit sensor for long time. Audible alarm is active when an alarm or board backup occurs with LTO option
Heller Industries Inc. | https://hellerindustries.com/wp-content/uploads/2018/06/593949_Ver8.0.0.9_Heller_oven-software-log-1.pdf
. Already compatible with recipes from 6.0.0.14a, 6.0.0.36, 6.5.0.14. - Corrected Overview studio crash related to current monitoring option selection - Corrected Cure SMEMA Belt stop issue when both belts and two lane smema is enabled. - Setup page1
GPD Global | https://www.gpd-global.com/co_website/pdf/doc/Dispense-System-User-Guide-22100079K.pdf
...................................................................................................................... 4.5 Stop Operations ............................................................................................................ 4.6 Safety Systems
GPD Global | https://www.gpd-global.com/pdf/doc/Dispense-System-User-Guide-22100079K.pdf
• Updated Emergency Stop & Power Off controls per new hardware, noting dif- ferences by dispenser model where needed. 12/02/2016 4.1 Improvements • SEMI S2 - replaced image-only warning graphics with SEMI S2 warning graphics that include both image and text box
GPD Global | https://www.gpd-global.com/co_website/pdf/doc/Infrared-Preheat-Module-User-Guide-22140087.pdf
code (2502) and key phrases (emergency stop, safety condition) Figure 12: 3. Clear all error issue conditions: a. Pull out Emergency Stop switch. b. Close all safety shields. 4. If a beeping alarm is sounding, Silence audible alarm (pg 22). 5. Touch the
ASYMTEK Products | Nordson Electronics Solutions | https://www.nordson.com/en/divisions/adhesive-dispensing-systems/products/controllers-and-control-systems/accubar-bar-code-verifier
; and ladder or picket-fence scanning. Protect product quality with faulty code detection that triggers an alarm, machine stop, ejector or marker
Heller Industries Inc. | https://hellerindustries.com/wp-content/uploads/2018/06/689011_Heller-XP_software_log_HC1_controller-4021.pdf
) - Board sense delayed output for water spray 4.0.0.3 Apr-27-06 - Added 2nd Custom alarm - Added option to use flux heater as standard heater (same as 3.0.1.7c
GPD Global | https://www.gpd-global.com/pdf/doc/Infrared-Preheat-Module-User-Guide-22140087.pdf
same as pressing the Emergency Stop button. Any time a Item Name Description 1 Status light tower Indicates machine status conditions by turning on colored lights (and audible alarm for certain conditions), each of which represents a given state. Refer