PCB Libraries, Inc. | https://www.pcblibraries.com/Forum/topic1204&OB=DESC.html
? The manufacture recommends a hole of .70 mm and does not recommend an annular ring. Clearly this can all be rectified by using the manufacture setting to enter something that will work
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/topic455&OB=ASC.html
". I recommend that when creating a BGA Footprint, that you use the "Mirror" feature. That will flip the BGA so that you are looking at the "Bottom Side" just like the datasheet
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/topic2412&OB=ASC.html
: 05 Jan 2012 Location: San Diego, CA Status: Offline Points: 5376 Post Options Post Reply Quote Tom H Report Post Thanks(0) Quote Reply Posted: 02 Dec 2018 at 6:15pm I recommend that you select "Help
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/topic1204&OB=DESC.html
? The manufacture recommends a hole of .70 mm and does not recommend an annular ring. Clearly this can all be rectified by using the manufacture setting to enter something that will work
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/multiple-same-footprint-name_topic797&OB=ASC_page3.html
. I have found this mechanism to be very effective and would recommend considering it for your footprint names. I will also give my vote to a separate Suffix field which is always added to the end of any autogenerated name
GPD Global | https://www.gpd-global.com/pdf/dispense/Weight-Scale-Process-Calibration.pdf
– to calibrate pump performance. Some fluids change viscosity over time; therefore, we recommend performing a calibration at intervals suited to a particular fluid and its tendency to change
| https://www.eptac.com/faqs/ask-helena-leo/ask/cutting-solder-joints-not-during-lead-trimming
: I’ve seen this type of trimming done a couple of times before and I can’t find anything that states it is not acceptable. I’ve never seen it used to trim a solder joint and would not recommend this at all as this is not good workmanship practice to trim solder joints to reduce the excess solder
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/RSS_idf-export-from-mentor-pads_topic1876.xml
and the terminals fall off the pads, we probably would not recommend the mfr. pattern unless they make a statement that it is necessary to do so
| https://www.eptac.com/soldertip/soldertip-46-open-connections-found-on-bga-components/
. The same condition can occur if the PCB itself warps and twist during the soldering process. I would recommend reviewing the thermal profile and the warp and twist characteristics of both the board and the components
ASYMTEK Products | Nordson Electronics Solutions | https://www.nordson.com/en/divisions/efd/fluids/sealant
. We also recommend the 725D piston valve for sealant dispensing at low pressures. In addition, when high-speed sealant dispensing is required, EFD recommends the Liquidyn jet valves
winsouce.jpg)