GPD Global | https://www.gpd-global.com/co_website/pdf/lead-former/CF8-Calculator-Software-Guide-8201622.pdf
7.0 SYSTEM CONFIGURATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17 7.1 PASSWORDS & TWEAK ENABLES . . . . . . . . . . . . . . . . . 18 7.2 SET ACCESS LEVELS
GPD Global | https://www.gpd-global.com/pdf/lead-former/CF8-Calculator-Software-Guide-8201622.pdf
7.0 SYSTEM CONFIGURATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17 7.1 PASSWORDS & TWEAK ENABLES . . . . . . . . . . . . . . . . . 18 7.2 SET ACCESS LEVELS
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/line-properties-grayed-out-how-to-change_topic1976_post8139.html
:00am In creating a footprint for a right angle LED I wish to be able to tweak the position of the legend detail. On selecting the Layer and then the line in question I find that the properties are grayed out and cannot be modified
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/topic1976&OB=ASC.html
:00am In creating a footprint for a right angle LED I wish to be able to tweak the position of the legend detail. On selecting the Layer and then the line in question I find that the properties are grayed out and cannot be modified
GPD Global | https://www.gpd-global.com/co_website/pdf/lead-former/CF8-Calibration-Setup-and-Alignment-Kit-821-1-115M.pdf
. Tweak Transport Wheels NOTE: All new or replaced transport wheels should be checked for a proper indicator reading prior to (re)assembly. 1. Use a clean, flat surface plate and wheel fixture for this procedure
GPD Global | https://www.gpd-global.com/pdf/lead-former/CF8-Calibration-Setup-and-Alignment-Kit-821-1-115M.pdf
. Tweak Transport Wheels NOTE: All new or replaced transport wheels should be checked for a proper indicator reading prior to (re)assembly. 1. Use a clean, flat surface plate and wheel fixture for this procedure
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/how-would-you-create-the-ti-rse-package_topic767_post2724.html
. However, I find that using the tool to create the basic part and then tweak it in the CAD tool editor gets me way up on the library consistency curve
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/fp-designer-origin_topic1063_post4239.html
. However I don't agree with Jeff, there should be a way to restore the origin to the center (or original) location of a part. The whole point of FP Designer is that you can go back and tweak your existing designs without having to start over
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/topic1063&OB=ASC.html
. However I don't agree with Jeff, there should be a way to restore the origin to the center (or original) location of a part. The whole point of FP Designer is that you can go back and tweak your existing designs without having to start over
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/topic474&OB=ASC.html
Thermal pad length (dimension "E2"). In that case, you should always Tweak the E2 dimension so that the Pad Length is at least equal to the mfr
