Used SMT Equipment | Soldering - Wave
2005 Speedline Technologies Vectra 450F Wave Solder Note: The solder pot is full of lead-free solder. The weight of this solder is estimated at 1600 lbs. Item Location: Westerville, OH USA Serial: 498509 Features: Ultra Fill Lead-Free OptiFlux II Int
Used SMT Equipment | Soldering - Selective
Details: • 12” x 12” Solder Range • Used for leaded solder, but is lead-free capable • Closed Loop Servo Motion of Solder Pot • Miniwave and Fluxer below PCB • XYZ Robotics Motion • Solder Management system-(Pot, Pump, Riser, Nozzles, Level Sen
Used SMT Equipment | Soldering - Reflow
Novastar GF12 Reflow Oven Equipment Description Novastar Model Number: GF-12HC/HT Serial Number: 1101232 Year 2011 Max Board Width: 12" Max Temperatute: 350C or 622F Heated Tunnel Length: 26" 3 Zones top, 3 Zones bottom Venting: 4" fla
Used SMT Equipment | Soldering - Reflow
Very Nice Thermotron Oven For Sale The oven is very clean with low use and in very good condition Both heating and cooling is working nice! See attached pictures and information below. •Thermotron Oven •Model Number: S-32C •Serial Number: 512/25
Used SMT Equipment | Screen Printers
Right; Right->Left; Left-> Left; Right->Right Transport Speed: Max 1500mm/S ProgrammablePrinthead: Two independent motorized printheads Squeegee Speed: 6~200mm/sec Squeegee Pressure: 0~15Kg Squeegee Angle: 60°/55°/45° Squeegee Typ
Used SMT Equipment | Soldering - Wave
Electrovert Econopak Plus Wave Solder Machine • Finger Conveyor • Foam Fluxer • 2 bottom Convection Pre-Heat • 2 Top side Stainless Steel Deflector Plates over Pre-Heat • 16” Usable Single Wave • Cast Iron Solder Pot • Roll-out solder pot •
Used SMT Equipment | Soldering - Reflow
6 bottom and top vertical heating zones plus cooling zone • Low mass 20" wide stainless steel conveyor, 18" max process width. • Easy lift clamshell design with gas strut assist • Status light tower FOB: Origin Contact:
Used SMT Equipment | Conveyors
2007 Nutek Wave Solder Entrance Conveyor 220VAC Single Phase Power, L to R Board Flow, Speed control, Adjustable Height and Angle, Edge Hold Stainless Steel Pin Chain with Hold Down Guides, 16" Max Board Width, available as powered up and tested
Used SMT Equipment | Soldering - Reflow
Electrovert Infraflo 500C - Reflow Oven -Ten (5 upper, 5 lower) panel type metal face heaters -PID control -Surface mounted thermocouples for quick response -Stainless steel construction of heating chamber -Edge heaters to fine tune temperature
Used SMT Equipment | General Purpose Equipment
Upgrade your wave solder machine with the Spray Fluxer to: 1. Replace a foam fluxer or an obsolete spray fluxer. 2. Achieve a true no-clean process. 3. Implement a lead-free process. 4. Please refer to attched operatio