Industry News | 2021-12-08 20:33:21.0
Refrigeration compressor is a kind of driven fluid machinery, which promotes low-pressure gas to high-pressure gas and is the heart of refrigeration system. The refrigeration compressor sucks the refrigerant gas of low temperature and low pressure from the suction pipe, then drives the piston to compress the gas through the motor operation, and finally discharges the refrigerant gas with high temperature and high pressure to the exhaust pipe to provide power for the refrigeration cycle, so as to complete a refrigeration cycle: compression → condensation (heat release) → expansion → evaporation (heat absorption) Compressors can be divided into piston compressor, screw compressor, centrifugal compressor, etc.
Industry News | 2018-12-13 02:06:08.0
Maintain the Pick And Place Machine
Industry News | 2021-12-27 20:26:21.0
When speaking of air conditioners, everyone is familiar with them. Especially in the hot summer, we would not know how to live without it. But when it comes to refrigeration compressors, many consumers are not particularly clear. In fact, the refrigeration compressor is an important part of air conditioners and refrigerators, and its performance and quality directly determine the cooling effect of them. The following is an introduction to the types of refrigeration compressors.
Industry News | 2021-08-29 21:11:45.0
A compressor is a kind of driven fluid machinery that elevates low-pressure gas to high pressure. It is the heart of the refrigeration system. It inhales refrigerant gas with low temperature and low pressure from the suction pipe, compresses the piston driven by the motor, and then emits refrigerant gas with high temperature and high pressure to the exhaust pipe to provide power for the refrigeration cycle.
Industry News | 2021-12-17 20:20:03.0
As we know, the operation of the internal compression structure of the refrigeration compressor has a fixed direction. First of all, we should make it clear that the reverse rotation of the compressor is adverse. Scroll refrigeration compressors can only compress in one direction of rotation. Single-phase compressors always start and run in the correct direction, except in the case of instantaneous power failure. The direction of rotation of the three-phase compressor is determined by the phase sequence of the power supply, so there is a chance that the compressor will rotate reversely.
Industry News | 2021-08-19 23:53:44.0
As we know, compressors have been applied in a wide range in industry. And this article will take you to look at things about reciprocating compressor bearing bush failures.
Industry News | 2021-08-15 23:15:17.0
A servomotor refers to the actuator to control the operation of mechanical components in the servo system and is a subsidy motor indirect transmission device. The servo motor can control speed, whose position accuracy is high, and convert voltage signal into torque and speed to drive the controlled object. A servomotor speed is controlled by the input signal, responding quickly.
Industry News | 2021-12-24 20:18:41.0
The throttle Position Sensor (TPS), located on the butterfly spindle, is operated by the throttle, and its installation varies according to the structure. For a traditional mechanical cable throttle, the throttle position sensor is usually installed on the side of the throttle body in the form of an independent component. And its rotation openness is driven by the throttle shaft, as shown in figure 2. For the commonly used electronic throttle, the throttle position sensor is integrated into the electronic throttle control component, as shown in figure 3.
Industry News | 2021-12-14 20:10:25.0
When the current flows through the stator winding, the stator winding produces a vector magnetic field. The magnetic field will drive the rotor to rotate an angle, so that the direction of magnetic fields of the rotor is consistent with that of the stator. When the vector magnetic field of the stator rotates an angle, the rotor also rotates at an angle with this magnetic field. Every input of an electric pulse leads the motor to rotate at an angle to advance one step. The angular displacement of the output is proportional to the number of pulses input, and the speed is proportional to the pulse frequency.
Industry News | 2020-11-06 17:41:10.0
South-Tek Systems is pleased to announce the appointment of Mr. Don Dennison as their manufacturer's rep covering Southeastern New York, New Jersey and Eastern Pennsylvania.
.png)
