Industry News | 2003-03-11 08:45:00.0
CAMtastic DXP is the latest version of Altium's complete CAM verification and editing system that bridges the gap between PCB design and manufacturing and facilitates communication between board designers, fabrication engineers, and their clients.
Industry News | 2017-01-25 16:39:34.0
Singulating tab routed printed circuit cards in low to medium volume production quantities is safe and easy with the N100 Nibbler from FKN Systek. Blades are available in standard thicknesses of .120”, .093” and .062”. Custom sizes to match the width of the routed section can be ground. Tabs are cut cleanly on each side so that no further clean up is required to remove excess material, as is often the case when using hand tools or when breaking the panels manually. In addition, since only one tab is cut at a time, minimal stress is imparted to the board during the process as the panel is not pressed between two points during the cut.
Industry News | 2022-02-17 12:52:30.0
Cleanly and easily separate a row of up to 10 tabs without dust. Singulating tab routed printed circuit cards in low to medium volume production quantities is safe and easy with the N115 Nibbler from FKN Systek. Two sharp support blades on either side of the tab help cleanly slice the PCBs from the tabs.
Industry News | 2022-09-21 08:26:26.0
Cut up to 10 Tabs in one Stroke
Industry News | 2019-09-06 14:46:04.0
THREE BLADE CHOICES FOR SINGULATING RECTANGULAR TAB ROUTED PCBS CLEANLY SINGULATE STANDARD AND FLEX CIRCUIT PANELS WITHOUT DUST Cleanly
Industry News | 2018-10-18 10:49:25.0
Panelizing PCBs with Tab Routing
Industry News | 2021-05-20 06:06:50.0
Turning large electrical power loads such as motors, lighting and heaters on and off is a common automation requirement. Applications are found in commercial buildings, industrial equipment and vehicles. The fundamental device for switching electrical power is called a contactor. Contactors are basically beefed-up relays, but with some specialized features for handling high power loads.
Industry News | 2021-05-24 01:06:02.0
Hazard Area are areas where volatile or flammable substances, such as fuel, gas, or flammable dust are present. Personnel working in those are typically wearing heavily protected clothes, face protection, ear protection. The normal communication method is not suitable in these situations. Special communications methods are used in these situation.
Industry News | 2008-09-08 18:44:30.0
COLORADO SPRINGS, CO � September 4, 2008 � Virtual Industries Inc., a leading supplier of manual vacuum handling solutions, introduces the V3025-B vacuum interrupter.
Industry News | 2019-11-05 22:24:42.0
Designing a PCB for automatic assembly and full production runs requires a few design changes from an initial prototype PCB run. Today most PCBs are assembled and tested with automated machines from the data from PCB drawing files. With up to 80% of a new product's cost determined by the first prototype build, avoiding late changes and designing with manufacturing in mind can have a significant impact on the product cost, reliability, and yield of a PCB design. Luckily, if some good choices are made early in the design process, designing a PCB for manufacturing is relatively straight forward with few pitfalls.
