Electronics Forum | Fri Sep 18 10:58:04 EDT 2015 | adventurelights
Thanks, have checked the vacuum tube and ribbon cables. They seem to look ok. Theta motor seems to be woking. I'm leaning towards the theta encoder going wanky. Is that possible?
Electronics Forum | Thu Oct 01 15:25:09 EDT 2015 | adventurelights
Which encoder did you replace? The one sitting on top of the midas shaft and below the small board or the one attached t the motor next to it? I don't even know if the first one is an encoder.
Electronics Forum | Tue Oct 06 15:11:09 EDT 2015 | alexvolovich
From what I remember, the round encoder on top of the Zfi head comes preassembled with the shaft. It's made in Germany. I don't remember the manufacturer, but the name and p/n might be on the label.
Electronics Forum | Thu Dec 10 15:14:25 EST 2015 | dyoungquist
We have had very good after sale support from Mycronic (Mydata). They can do high volume (speed) but where they outperform many other brands is their lower setup times. If you do high mix, low/medium volume I would recommend them.
Electronics Forum | Thu Jan 14 15:44:20 EST 2016 | sssvajunas
Hello, after we finish project (mydata) we unload tape from feeder and place a stick on the edge of tape. Maybe somebody can help with alternatives to this? (plastic clips) becouse then unloaded tape is used for another project it is sticky
Electronics Forum | Fri Jan 15 09:55:58 EST 2016 | dyoungquist
Mycronic (Mydata) makes a solution for this. Product name is Tape Seal 8 or Tape Seal 1216 Tape Seal 8 - Part No: L-014-1600 Tape Seal 1216 - Part No: L-014-1572 I have used them and they work well.
Electronics Forum | Wed Nov 16 16:25:19 EST 2016 | douglashaines
Thank you for the recommendation.
Electronics Forum | Thu Dec 15 12:45:15 EST 2016 | emeto
llllGodly, I did try before, but it wouldn't pick it - it will automatically select a tool for the single head. Do you think it has something to do with the fact that IO used ODD SHAPE recognition?
Electronics Forum | Fri Dec 30 09:37:53 EST 2016 | dyoungquist
Package screen and select the package you have programmed for the capacitor. Next press F3 to edit accelerations. In the popup screen set the X and both Hydras to low or lowest. That should accomplish the slow motion you are after.
Electronics Forum | Fri Dec 30 09:52:24 EST 2016 | emeto
Thanks, I will try that and we will see how it goes. Do you know what is the limit for component Height for Hydra heads?
.gif)
