Electronics Forum | Sat Feb 04 09:36:51 EST 2012 | davef
You bet. Using a high temperature solder is a perfectly reasonable way the attach thermocouples. Just remember that the solder will not flow on the thermocouple. You need to use a solder iron to lay the solder over thermocouple to hold it in place.
Electronics Forum | Thu Feb 09 09:18:22 EST 2012 | swag
I'm not familiar with Quad but I have had very similar problems on printers. If your conveyor has an L-bracket over the top of the conveyor belt to keep it down + aligned, you might need to remove it for cleaning or make some adjustments to it so it
Electronics Forum | Tue Feb 07 05:41:20 EST 2012 | ngineer
I've got an issue, i can't seem to figure out. I think I need to apply a global offset to all my placements for some reason, and I would like to know why, before I do it. nozzles work, picks seem ok, but the placements are off by about 1/2 the widt
Electronics Forum | Wed Feb 15 17:16:54 EST 2012 | davef
To get started look here: http://www.smtnet.com/Forums/Index.cfm?CFApp=1&Message_ID=61862 On your lingering disbelief of your suppliers truthfulness in the C of C: Periodic auditing of their truthfulness by your QA peeps or a third party is an acce
Electronics Forum | Fri Feb 17 12:22:50 EST 2012 | joeln
I am planning a PCB design for automated assembly of all components, SMT. I have been told that the industry standard used at the assembly house is something called "88", and that the assembly house can do better "55" or even "44". I’m not sure if
Electronics Forum | Mon Feb 20 13:43:54 EST 2012 | acsscott
Having a problem at power up, that our Philips Topaz X displays "DOWNLOAD IO STN.DATA NG" in red. It times out after about 5 minutes, then comes up. When we try to find the origin, it gives an error that the "Head Down sensor is OFF". If we go int
Electronics Forum | Tue Feb 21 10:15:07 EST 2012 | vinitverma
Forgot to mention. To disable the LCS you need to disable it in the machine config - by changing Tray Changer to NONE. Of course for this you will need the password which is "specialist". After setting this in the software, you also need to remove t
Electronics Forum | Tue Feb 21 10:45:45 EST 2012 | acsscott
Thanks for the password. There is a 7 pin connector for the Emergency stop in and out. It has a mate with a jumper wire attached to the Topaz end. If you put the jumpered mating connector on this, the emergency stop errors go away. The other conn
Electronics Forum | Fri Feb 24 07:28:11 EST 2012 | duso02
If you are going to coat very low volumes then just spray it by hand. The automated machines just won't be worth it unless you are going to do a very large run. They are complicated, require constant attention, still require masking the board and are
Electronics Forum | Mon Feb 27 09:31:30 EST 2012 | pauld
Hi Dave, Picture a camera mounted on top of a fixed base that pans 360 deg. back and forth. The motor connects through a circular slip ring board with brush connection. The rings are hard gold and the typical brush material is soft. Unlike the armatu
.gif)
