Electronics Forum | Mon Feb 12 13:09:52 EST 2018 | griinder
I see. As you say, Fid coordinates or good measurements should make it easier. 2d inspection setup at the machine may be a little more difficult. Thank you for the clarification. The Momentum's Vision is not inverted, it displays as if you are lookin
Electronics Forum | Sat Feb 10 10:01:25 EST 2018 | mdang
Could anyone help me how to create a new device package for inspection in Yestech software version 2.7. Thanks, -Michael
Electronics Forum | Sun Feb 11 21:56:20 EST 2018 | asvimani
Once i switch on the cm-402(panasonic) mounter machine, it directly shows the following error-"take down the PCB support table". i tried changing card no-5 for I/O. Please help me by providing suitable solutions for the above threat. thank you...
Electronics Forum | Wed Feb 14 13:12:12 EST 2018 | dph150
I have a Heller 1800S reflow oven the thing runs fine but when I have to change profiles the oven will have to be cooled down to room temp before it will change. Has anyone seen this or know how to fix it? Thanks, David
Electronics Forum | Wed Feb 14 19:37:51 EST 2018 | ricardonascimento
Hi, Mr. and Mrs. I'm in Brazil and I need printer MPM model 2030 software. The image of some other hd can also help me a lot. Can someone help me? Thanos Ricardo Nascimento
Electronics Forum | Thu Feb 15 10:14:45 EST 2018 | ameenullakhan
Hi All, Please help me in suggesting a technical paper or document. Which can help to design a good smt stencil to optimize smt solder paste printing at first time. Regards, Ameen
Electronics Forum | Thu Feb 15 17:08:34 EST 2018 | davef
IPC-7525A - Stencil Design Guidelines http://www.ipc.org/TOC/IPC-7525A.pdf
Electronics Forum | Fri Feb 16 08:28:54 EST 2018 | emeto
Here is a small part of my collection. If you need anything more specific, please let me know.
Electronics Forum | Fri Feb 16 10:27:48 EST 2018 | ameenullakhan
Thanks a lot Evtimov, For sharing your collection. Will go through it and write back if any doubts for your help :) Thanks again. Regards, Ameen
Electronics Forum | Fri Feb 16 10:36:44 EST 2018 | ameenullakhan
Thanks Rob, You are right. unique for us here might be common some where else. Will work more closely with our solder paste and stencil suppliers.. :)