Electronics Forum | Fri Jun 03 09:17:00 EDT 2016 | designhaus
Hi, > > if I were you, I would probably go for > testing and rework equipment. Adding > manufacturing to your business, will most > probably exceed your preliminary expectations. > Manufacturing is much more complicated than you > probably thin
Electronics Forum | Fri Jun 24 22:36:17 EDT 2016 | yokywong
now days, I face a problem for JUKI electric feeder and machinery feeder. i do not know about any of electric feeder. until now, we all use machinery feeder for CF081ER 7' real holder and 15' real holder,CF03HPR ,FF12FS,FF16FS,AF24FS-OP. but this tim
Electronics Forum | Mon Jul 25 03:39:25 EDT 2016 | rob
A 200% + increase in load time certainly erases > any thoughts of efficiency in my mind. We have tried the Visker Electric feeders out (Yamaha & Juki)and they are nice and smooth, with a faster recovery rate, also adjustable pitch. However, with
Electronics Forum | Tue Aug 09 11:14:28 EDT 2016 | cyber_wolf
•Rated Speed of 40,000 CPH •140 - 8mm Device Locations •14" x 18" Max PCB Size PCB dimensions Max: 457mm x 356mm Min: 80mm x 60mm Board Thickness: 0.3 to 4.0mm Component capacity Up to 140 types (8mm tape) Placing rate 0.09 sec./component - 40,
Electronics Forum | Tue Oct 25 11:48:03 EDT 2016 | dontfeedphils
Hi, we're currently running a design with a fairly simple BGA. The problem we're running into is poor solderability (cold looking joints, high voiding in the BGA). All of this on a know good oven, with a known good thermal profile. I'm guessing it
Electronics Forum | Sat Nov 19 03:15:39 EST 2016 | sarason
Does the file come off of an ICT. Next question is it an AGinet/HP/Keysight 3070. If so you have a chance at finding out the format. It is probably posted online in the Keysight manual downloads section. I might still have an old paper copy of this
Electronics Forum | Wed Nov 23 19:50:23 EST 2016 | gmscribe
Hi guys, I'm working on a design involving a 223-pin BGA with 0.5mm pitch (ball size 0.3mm) with a 16-bit DDR3 controller involved. Currently routing a track between two balls is resulting in a track width of 0.1mm and a spacing of 0.077mm. Now the
Electronics Forum | Thu Jan 05 01:44:22 EST 2017 | soldertraining
In modern education, almost every Electronic Engineer must design a PCB. Once you get to know PCB design tools and functions, then creating a layout will become easier. Today, we find 0.4 mm pitch BGAs in every smartphone, and 0.3 mm ultra-fine pitch
Electronics Forum | Tue Mar 14 13:00:38 EDT 2017 | stephendo
I had a nitrogen salesman in yesterday. He brought his technical support person with him. He said he could add a pre-filter just before the machine regulator. I asked him about it and he said that if you get a pin-prick hole in your piping you can
Electronics Forum | Wed Mar 22 14:59:20 EDT 2017 | solderingpro
Hello Henry, I believe some further clarification may be needed for someone to assist. Is the component already soldered prior to reflow? Does the component have paste already applied going through reflow? (or as per my previous question, is it al