Electronics Forum | Wed Dec 03 11:31:24 EST 2003 | russ
Does anybody out there know what type cable is used for the controller cable on an LSM large model circa 1996? Is it a standard 25 pin D-Sub? This is the cable that goes from the XY Axis line box to the controller. I have contacted Cyberoptics and t
Electronics Forum | Tue Dec 16 04:03:35 EST 2003 | ex maintain leader
www.adopt.co.at 2nd hand dealer in Austria www.wlw.at is a free database. look also this page listed companies If you need more help write me an email to san in and send my relationschips. I'm an Hungarian ex FUJI service engineer and an ex maintena
Electronics Forum | Mon Jan 05 18:03:04 EST 2004 | davef
You may struggle finding the information that you seek, because there is so much variability in the design and fabrication of boards. * What is the purpose of such a test? * What product type sees such an use environment? Consider using the guidelin
Electronics Forum | Wed Jan 14 03:45:45 EST 2004 | Bryan
Whether could we add some heating or cooling modules to the 8 zone reflow oven and convert the 8 zone to 12 zone or more?I 've never heard of anybody successfully done this.I think, this way, we could get more cost down.What's your opinions? Thanks®a
Electronics Forum | Tue Mar 02 21:05:38 EST 2004 | Ken
Has anyone in the US used this system? I am told that over 1000 systems are operating world wide...but find it hard to believe no one domestically is using this (if it in fact is worth its salt would more not use it?) Anyone? Anyone demo'd this? A
Electronics Forum | Tue Feb 10 14:02:03 EST 2004 | Maryann
At times the orange peel effect can be from excess flux improperly removed. Our company strictly provides the service of selctive conformal coating application. We quite often see this. Most times if the board is simply "water washed", or IPA washed,
Electronics Forum | Wed Jan 28 14:03:47 EST 2004 | Bobvsi
Larry, For what it is worth, we were in the same boat last year, and we went with MyData. The service and support have been phenominal thus far. The machine is accurate and easy to changeover and teach new boards. The biggest negative we found is fe
Electronics Forum | Tue Jan 27 18:05:03 EST 2004 | sanfordjoe
I have been asked by my University to look into the possibility of bringing SMT production capability to one of our labs. However, I have no experience with these types of machines. When I am looking for these machines, what would be some intelli
Electronics Forum | Wed Jan 28 10:14:03 EST 2004 | danielinsa
All � I am trying to change my rating method for end item assemblies provided by my CM. I am currently using a simple yield method based on total PCBA�s received vs PCBA�s rejected. I have considered PPM but am leery due to the high mix rate and fluc
Electronics Forum | Thu Feb 12 12:03:02 EST 2004 | pjc
The reality is mfg jobs worldwide are going down down down. In fact Asia lost way more mfg jobs - in terms of numbers, not percentage - than NA and Euro. The fact of the matter is less and less people are needed to make more and more products. Pretty