Electronics Forum | Mon Aug 13 08:04:43 EDT 2007 | davef
Search the fine SMTnet Archives [on gold finger], while you're waiting for others to reply. For instance: http://www.smtnet.com/forums/Index.cfm?CFApp=1&Message_ID=42759
Electronics Forum | Mon Aug 13 08:16:19 EDT 2007 | davef
Your theory is reasonable about a component issue. You need to investigate the solderability of the pads on the BGA interposer.
Electronics Forum | Mon Aug 27 08:03:32 EDT 2007 | davef
Actually, you will be soldering and wire bonding to the palladium layer, so we should have asked if you checked that layer, rather than the nickel. We not sure of the source of the copper that your see on EDX. It's possible copper from the pad migra
Electronics Forum | Wed Aug 22 08:46:33 EDT 2007 | marcelll
Happen to me on a conveyor after a GSM but not a PCT. Had to install small caps to kill the noise on the conveyor PLC input from the GSM. Also, might be a question of timing betweem th GSM and the conveyor.
Electronics Forum | Fri Aug 24 09:29:08 EDT 2007 | jgrootkoerkamp
Solder balls with wave soldering can have different causes. The two most important are the solderresist and the flux. I have similar problems, after changes the flux type 90% off all solderballs are gone. KR, Joris Groot koerkamp
Electronics Forum | Fri Aug 31 00:08:10 EDT 2007 | ventron
Hi all, Please help me to solve this problem: When I turn on MCS30, it couldn't boot. It appears this error: " BOOT DEVICE ALL FAIL !". Please help me ASAP. Thanks,
Electronics Forum | Mon Oct 08 03:53:08 EDT 2007 | d0min0
Hi, we do stepper motor assembly, and "use" both methodes; coil is selective soldered before entering line and then coils & I/O connector are soldered to PCB with robot (in many points also manual soldering) regards Dominik
Electronics Forum | Thu Oct 18 08:08:19 EDT 2007 | chrisatae
We're looking for a high mix low volume paste printer. What are the Pro's and con's of the Opti Print 2020? I looked at the spec sheet and it looks like it will do what we need but usually there are issues during setup and operation. Any info would
Electronics Forum | Thu Nov 08 08:56:51 EST 2007 | hussman
Sorry Matt, Just hate when people use this site as their engineering bed. I believe you can weigh your board before and after reflow. It would have to be a sensitive scale though. From there you can calculate weight to volume ratios.
Electronics Forum | Fri Feb 08 08:29:25 EST 2008 | mmjm_1099
You can do what someone at heller mentioned to me to check if the exhaust is working properly. Take a baseball cap place it by the opening to the vent and if it wants to suck in the hat your good to go. Cost $12.00