Electronics Forum | Wed Sep 01 01:47:43 EDT 2010 | markhoch
Sheesh Mike. Can I get you to do my homework too? I've got a term paper coming up on Forcasting Advancements in Artificial Intelligence. Due in two weeks. Let me know when you've got a rough draft I can critique. ;)
Electronics Forum | Tue Sep 07 12:57:00 EDT 2010 | jrr3434
Thanks for the info mike. How well do these batch cleaners work with densely populated through hole boards that were solder with no clean flux? Is there a problem with water getting trapped under large capacitors? I'm using kester 959t for flux on b
Electronics Forum | Wed Sep 01 05:23:08 EDT 2010 | leeg
We are having solder bridges on a fine pitch QFP and was wondering whether printing speed directly affects the bridging and is there a typical formula to work out print speed?
Electronics Forum | Wed Sep 01 05:43:08 EDT 2010 | ranco13
Hi, does anyone has any experience waht so ever with waterman wave soldering with 7 lines of holes? We are now planning to take our assembly line to waterman 7 lines, instead of 5.
Electronics Forum | Wed Sep 01 11:13:23 EDT 2010 | soudomphong
I am looking to replace the flip chip camera for HS60. Does anyone know of a good use camera, and price for it? Thanks, Seth
Electronics Forum | Wed Sep 01 16:33:33 EDT 2010 | smellew
Mike, I don't know this loader, but if you link 3&4 locally on the downstream conveyor, this should make it request PCB from loader via 1 & 2 PCB should then unload.
Electronics Forum | Wed Sep 01 18:14:17 EDT 2010 | swag
We had that happen on rare occasions and got the live vision display back by exiting enhanced board and re-entering or by power cylcing the machine. If that does not work, I don't know how to help you.
Electronics Forum | Thu Sep 02 03:00:59 EDT 2010 | sachu_70
Hi Kevm, would it help to try solderability test of these pads using an agressive flux during soldering? Just a thought.
Electronics Forum | Thu Sep 02 11:45:47 EDT 2010 | kevm
We have tried solderability testing using an agressive flux and have had good results. However, our Mfg process uses laser soldering equipment which is a validated process and we are limited on the type and amount of flux we can use due to ionic cont
Electronics Forum | Fri Sep 03 08:25:30 EDT 2010 | remullis
I removed the muffler yesterday and still had the latch releasing issue, the latch was tight, however the table had some play in it. I adjusted the play out of the table, setup table zero and it fixed the problem. Same symptom as if the latch were lo