Electronics Forum | Mon Sep 02 03:58:46 EDT 2013 | raqz
Thank you very much for your comments. I highly appreciate your opinions. Does this mean that batch oven are no good? Not even one? I am still hoping that there is at least one batch oven that you can recommend. Thanks!
Electronics Forum | Sun Sep 01 05:39:36 EDT 2013 | leardkattiya
Hi, can someone give definition on pot life? does the pot life start once it's been taken out from fridge or the pot life starts once recommended thawing ends?
Electronics Forum | Sun Sep 08 18:19:58 EDT 2013 | davef
Not quite what you're asking, but try OEE as your metric http://www.smtnet.com/index.cfm?fuseaction=search_submit&searchstring=oee&collection=site_forum BR, davef
Electronics Forum | Wed Sep 04 20:29:56 EDT 2013 | saibot
We had that problem a few months ago with one of ours. Had to replace both y-axis motors and the tech said it's a common problem with the Opal-XII.
Electronics Forum | Wed Sep 04 13:25:28 EDT 2013 | charliedci
Try cake decoration websites. They have nice wooden handled, aluminum, rounded 4-5" blades.
Electronics Forum | Fri Sep 06 11:39:06 EDT 2013 | thanh567
Indium Corporation has their plastic spatulas and perfect to use, good on jar and stencil as well.
Electronics Forum | Thu Sep 05 22:01:55 EDT 2013 | davef
Questions are: * How did you determine that the coating on your component leads is oxidation? * What is the oxide? BR, davef
Electronics Forum | Thu Sep 05 23:32:29 EDT 2013 | winson16
This connector was designed with gold flash plating and the lead's surface was become dull and some black mark was observed on the contact surface.
Electronics Forum | Fri Sep 06 07:40:02 EDT 2013 | spoiltforchoice
gold, one of the stablest elements on the periodic table oxidising. Are you sure, and why would you want to reduce the vision fail rate on a part that is clearly shockingly poor?
Electronics Forum | Mon Sep 23 14:26:27 EDT 2013 | joekirin
On machines such as MyDatas you have the ability to mechanically center parts rather than optically centering. If your machine is capable of doing mechanical centering that would eliminate the need for the vision analysis. -Joe