Electronics Forum | Mon Nov 09 12:12:41 EST 2009 | mcmark
Same here, I've been programming Mydata placement machines using CircuitCAM since 1999, at 2 companies. With an ASCII CAD file imported and simple BOM scrubbing, we can get programs directly output to our Mydatas in less than 5 minutes. Developing as
Electronics Forum | Mon Nov 09 14:51:53 EST 2009 | jlawson
vPlan from Valor also is strong with Mydata, from general validated, scubbed, centroid corrected, rotation corrected outputs (same sort of times as mentioned with Aegis users to full optimistation part data generation on demand....(Aegis can not offe
Electronics Forum | Tue Sep 08 07:07:55 EDT 2009 | davef
We think the idea is to avoid boiling-off the moisture and let it 'cook-off' at a lower temperature to decrease the potential damage to components. If you heat a pan of water on the stove below, but close to the boiling point of water, the water in t
Electronics Forum | Tue Sep 01 05:28:49 EDT 2009 | aj
start skipping out some parts and try to transmit? could be a dodgy part data... Best thing to do is skip out everything except one part and see how you get on with the transmission and work from there. If it transmits start addin a few more until y
Electronics Forum | Wed Sep 02 11:36:22 EDT 2009 | kpm135
Is this an established process that is just now exhibiting these problems, or is this a brand new process you're just setting up? What is the rest of your process like? What is done to the boards before you coat them? Water washed? Solvent washed? Sa
Electronics Forum | Thu Sep 10 15:01:28 EDT 2009 | mefloump
I currently spray DOW 2620 with my PVA650 without any problems. I do not thin it but I do have a distance between the coating machine and IR oven to provide a flash off period. I notice bubbles only when the flash off time is too short and the coatin
Electronics Forum | Mon Aug 31 09:33:28 EDT 2009 | jamyboy
You can save your boms and Partminer will let you search that data along with capturing what you paid last time the time before and maybe if there are any opportunities to get the part cheaper somewhere else. Helps us keep track of the parts we have
Electronics Forum | Tue Sep 22 08:35:47 EDT 2009 | cman
Did you try pre-tinning your board on this suspect pad/s to see if it improved wetting/solderability prior to printing/SMT placement and reflow? Does the pad/s not soldering tie to a ground layer? I would connect a T/C to each pad of the same part an
Electronics Forum | Thu Sep 24 04:49:45 EDT 2009 | d0min0
that crossed our minds - overloading of the oven but in reality we produce 5 references with very little output difference (close to 2 sec difference) so it should be a problem since a few yeats and on all references...? no only on 2 references from
Electronics Forum | Tue Sep 01 02:54:30 EDT 2009 | rocko
Hi davef, In response to your questions: 1) It is a programmable washer designed for the tough demands of industrial applications. There is an integrated forced air dryer with both coarse and HEPA filters. 2) The surface of the PCB panel, the comp