Electronics Forum | Fri Sep 18 03:02:07 EDT 2015 | linux
Hello everyone. Need urgent help with our cp6, when front door is open servo amp alarm comes up, this error will clear using the reset button. Has anyone any idea how I would go about fixing this issue.
Electronics Forum | Mon Sep 21 10:23:46 EDT 2015 | koprivecj
Please look at folowing link. http://shrani.si/f/3l/xt/3ZHqDv6X/padconnectproblem.png I think that there would be no problem with full pouring the via. But i don't know if it is good to fully pour the PAD in inner layers? Any suggestions?
Electronics Forum | Wed Sep 23 03:03:06 EDT 2015 | stivais
We are looking for an expert at Teradyne XSTATION MX, machine type 8022 AXI programming (2D, 3D). Is here anybody who has an experience with this machine?
Electronics Forum | Wed Sep 23 13:20:02 EDT 2015 | emeto
Depends on the MSL(Moisture sensitivity level) and how far you will use them in production. Here you should be able to get all the answers: http://www.jedec.org/sites/default/files/docs/jstd033b01.pdf
Electronics Forum | Wed Sep 23 23:10:26 EDT 2015 | richardcs
Does any one have calibration jigs for a DEK265 LT, a full manual with schematic would be good as well?
Electronics Forum | Tue Sep 29 20:44:36 EDT 2015 | dekhead
I can probably help you with manual and prints. Please contact me directly. www.dekhead.com
Electronics Forum | Thu Sep 24 07:14:39 EDT 2015 | mrnollid
What is the tolerance for inspecting a 28 pin IC in a socket? If it's not sitting flat to the socket, what height is acceptable?
Electronics Forum | Thu Sep 24 07:25:34 EDT 2015 | anilwagh
I have Cyberoptics SPI SE300 Ultra machine purchased from auction. I need service/Electrical/Program manuals.
Electronics Forum | Tue Sep 29 14:54:03 EDT 2015 | bmalhi
Voltage retrofit require some wiring changes along with circuit breakers replacement. Please contact serviceNJ@hellerindustries.com to get the retrofit quot.
Electronics Forum | Tue Sep 29 18:20:56 EDT 2015 | ercdave1
Rob,. thank you very much for the reply. I will follow your recommendations and verify that the stop bar is not damaged or misaligned. I will also thank you for the info for the service . I will keep you posted. Thank you again. David
